Flight Model CRICRI 70 Operation instructions

CAUTION : this plane is not a toy!
Before use , please carefully read this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
Wing Span:70in/1778mm;
Flying Weight:3000g;
Wing Area:39.3sq.dm;
Radio:6Channels 4Servos;
Length:55.1in/1400mm;
Outer Runner Brushless Motor:BL2819
performance to full extent .
P1

and hinges.
Attach the aileron to the
main wing with AB glue.
Cut away covering film for
the servo in the bottom of
the wing.
Install the servo to the
servo hole.
MAIN WINGS
Gather the mian wing,aileron
P2

Put the servo in the right
position,then fixup it,and
Assemble aileron、servo arm
and pushrod.
Insert the main wings with
joiner,then screw them by
nylon screws.
Put the Canopy into the right
position on the top of the
fuselage.
then With Canopy Locks tacks
the canopy fixed in the fuselage.
As the photo shown.
Install the Canopy
P3

Use 4 Screws fixed the stablizer
each side as the photo shown.
Install a servos ectention onto the elevator servo.Either
tie the srco leads together,or use a connector to secure
the extension to prevent it from coming loose during flight.
Another way
Stabliazer
RUDDER AND ELEVATOR
P4

Istall the front steering landing gear
into fuselage as photo shown.then put the ALU
landing gear into as photo shown fixed by four
3mm screws.
The steering connecting rod two sides was
connected by two regulators,one put in the servo
arm,and another one put in steering arm,between
the regulators there has one 1.5mm steel wire.
Cut a hole on the front wheel,the install the
front steering landing gear.
THE MOTOR INSTALLED
P5

Install the ESC as the photo shown.
Pls be attention that need cut a hole on
the cowl in order to let the ESC wires be
outside.
Use two screw fixed the Alu squares cap in the
alu squares,then put the motor cabinet fixed by
M3 screw.other side install locknut.
P6

Install the motor by M3 screws.
then let the motor line with
ESC line connected together.
First install the second
part as the photo shown.
then install the front part
as shown.
Install the Motor Cover
P7

In the middle part fixed by
tapping screw.
Assemble the receiver and
receiver battery as shown.
THROTTLE SERVO
P8

Install the undercarriage to
the bottom of the fuselage.
Permanently tighten the axle
to the gear strut by wrenches.
UNDERCARRIAGE
CG POSITION & CONTROL THROWS
P9

Flight Model CO.,LTD
ADD:No.10,Fu Ning Street,Xian Xi Industrial,Chang An Town,Dong
Guan City,Guang Dong Province,China
FINISHED PHOTO
P10

Tel: [phone]
Fax: [phone]
E-mail:[email protected] / [email protected]
Web: http://www.flight-model.com/product/eindex.asp
http://flight-model.preview.alibaba.com/
P11

P12

P13

the canopy fixed in the fuselage.
P14

Use 4 Screws fixed the stablizer
the extension to prevent it from coming loose during flight.
P15

P16

P17

then install the front part
P18

In the middle part fixed by
P19