Flight Model Katana-100CC Operation instructions

Caution:this plane is not a toy!
Before use ,please carefully read this
manual.
Flying Weight:11700-12700g;Wing Span:106.1in/2695mm
;
Wing Area:136sq.dm;
Length:93.3in/2370mm; Engine:100CC GAS;
Radio:6channels 9servos;

Cut away covering film for
the servo.
Attach the aileron to the
main wing with AB glue.
Screw the servo to the wing.
Put the servo extension
through the wing and pull
through the wing root rib.

Assemble 2 aileron servo .
Link the servo and
tri-horns with pushrod and
straper.
Find out the holes on each
sides and cut off the film
of fuselage.
Connect the main wings and
the fuselage with joiner.
Also pull the extension
into the fuselage.
L/R

Use 4 nylon screws of each
sides to ensure the wings
fixed upto the fuselage.
Glue wing tip by AB glue.
Fix up the wheel to the
screw by two collars.
L/R

Screw the wheel to the
landing gear.
Be assured that the screw
is fixed up.
Install the wheel cover,
and fix it up to landing
gear with two TP screws.
Bolt landing gear strut
to fuse with 4 bolts and
washers.Ensure tapered
edge of the gear strut is
facing toward the rear.
L/R

Measure the right position
and remove the film from
the stabilizer.
Glue the stablilizer to
the fuselage.
Connect the aileron and the
stabilizer by hinges, and
glue them.

Connect the rudder to the
fuselage by hinges by
AB glue.
Install elevator servo.
Insert rudder cable through
the brass swage tube,then
through the threaded
coupler hole,and back
through the brass swage
tube as shown.
L/R

Loop the cable back through
the brass swage tube as
shown.
Attach a metal threaded RC
link to each threaded
coupler.Attach the RC
links to the rudder servo
arm and then attach the
servo arm to the rudder
servo as shown.
Fix the tri-horns to the
fuselage as shown.

Attach straper to rudder
control horn on both sides
of the rudder.
Attach the tail wheel to
the tail landing gear as
shown.
Mount the tail wheel struts
and springs using four TP
screws.

Mount the tail wheel
steering tiller using
two TP screws.
Attach the steering springs
on both sides of the tail
wheel to the rudder tiller
and tail wheel tiller.
Center the springs between
both tillers.
Drill the engine mounting
holes as the board provided.

Assemble engine as shown.
Make sure tighten firmly.
Install inner muffler.

Assemble fuel tank.
Fasten the fuel tank with
nylon zipper provided.
Completed picture as shown.

Assemble movable canopy
which provide more convinient
for assembling.
Install electric equipment.
Install the cowling with
four TP screws.
4 screw provided to
lock canopy.

Balance test
A=A1
B=B1

CONTROL THROWS & CG POSTION

FINISHED PHOTO