Flight Model SBACH-342 User manual

Wing Span:64in/1625mm; Flying Weight:3700-4000g;
Wing Area:51.2sq.dm; Radio:4Channel 6Servos;
Length:63.8 in/1622mm; Engine:20CC Gas
CAUTION : this plane is not a toy and should be kept away
children under 16 years of age! Before use , please carefully read
this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
performance to full extent .
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
P.1

MAIN WING
Apply epoxy into
hinge hole of the wing
Connect the aileron and
the main wing by hinges.
Be sure to apply instant
type glue to both sides
of each hinges.
Cut the servo holes on the
bottom of the main wings
P.2

Use glue to fix up the
horns
Install push-rod,used ruler
to measure the length
Put the servo into the
hole and fix it with screws.
P.3

Link the servo arms and
tri-horns with pushrod
Drill the holes on the wing tips
Be assured that the screw
is fixed up
INSTALL WINGTIP WINGLET P.4

You can also install wingtip
winglet,as shown.
STABILIZER AND ELEVATOR
Cut the servo holes on the
profile of the fuselage
Fix up the stabilizer
of the fuselage
P.5

Apply epoxy into
hinge hole of the elevator
Fix up the stabilizer and
elevator with hinges and AB
glue.
Use glue to fix up elevator
horns
Install the servo in the hole
as shown
Be assured that the screw
is fixed up
P.6

Link the servo to
the elevator with pushrod.
RUDDER
Apply epoxy into
hinge hole of the rudder
方向舵粘合页
Use glue to fix up rudder
horns
P.7

Install the rudder servo
Be assured that the screw
is fixed up
attach the servo arm to the
ruddert servo as shown
As shown in picture, This is
finished for the rudder servo
P.8

MAIN LANDING GEAR
Fix up the landing gear
on the fuselage bottom with
screws.
●Bottom View
Put the cover board in the
right position,then fix up it.
Install the wheel as shown.
Install the wheel cover,
and fix it up to landing
gear with screw.
P.9

Install the tail landing gear
use screws to fix up the
fuselage bottom.
ENGINE
Drill the engine mounting
holes as the board provided
Use the ruler to measure
the length from firewall
to airscrew
P.10

Put the cover board in the
hole,then fix up it.
Install the propeller and
spinner as shown
FUEL TANK
Install the fuel tank into
the fuselage, and fix up it
with belt.
P.11

Install the fuel tank mounting
ties under the fuel tank floor.
Install the battery,receiver and
switch in place as shown.
CANOPY AND COWL
Install the canopy into
the fuselage as shown
P.12

Mount the cowl using the cowl
mounting screws.
CG POSITION & CONTROL THROWS
P.13

THE FINISHED PHOTO
THE FINISHED PHOTO
Another scheme for choice
Dong Guang Flight Model CO.,Ltd
P.14

ADD:No.10,Fu Ning Street,Xian Xi Industrial,Chang An Town,
DongGuan City,Guang Dong Province,China
Tel: [phone]
Fax: [phone]
E-mail:[email protected]
Web: http://www.flight-model.com/product/eindex.asp
http://flight-model.preview.alibaba.com/
P.15