Flight Model Extra 330SC 100CC User manual

Wing Span:106in/2693mm;
Flying Weight:11700g;
Wing Area:138sq.dm;
Radio:6Channel 11Servos;
Length:94.5in/2400mm;
Engine:100CC Gas
CAUTION : this plane is not a toy and should be kept away
children under 16 years of age! Before use , please carefully read
this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
performance to full extent .
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.

Main Wings
All the wing parts together
Cut the servo holes on the bottom of the main wings
Install the servo and fix it with screws.

Use 3*12 screws to lock the servo-tray to the Wing
Cut the film covering as shown
Insert the fiberglass control horn , and glue with AB glue

Connect the servo arms and aileron control horn by pushrod with ball links.
Finished photo
Install Wingtip & Winglet

Finished photo
Connect the main wings and the fuselage with Carbon fiber tube.
Main Landing Gear and Tail Wheel Unit
Gather the parts for the main landing gear.

Tail Wheel parts
Slide cuffs into position on the landing gear.perform a quick fit check on the fuselage
to verify cuffs are properly oriented
Use screw to connect the landing gear, wheel pant, nut and wheel
in turn, and finally use a lock nut to lock them.

Insert the wheels and axles into main landing gear with the nylock nuts.
Install the wheel cover,and fix it up to landing gear with screw.
Fix up the landing gear on the fuselage bottom with 4 screws.

Drill a hole at the Original design hole of the cuffs
Use screws to lock the cuffer and landing gear
Rudder
Put the steel wire in the hinges between the rudder and the connecter of vertail fin

Put the tail wheel set into the hole, and use two pcs self-tapping
to lock the tail wheel onto the fuselage tail.
Cut the film and let the steel wire outside.
Cut out the hinges film

Using a knife，remove covering the film above the gear plates
Insert the fiberglass control horn sheet and gear plates.
Use AB glue to glue it.
Connect the rudder to the fuselage the horns into the original design hole

Install the rudder servo,as shown
Put the servo into fuselage
Use screws to fix up the servo on the fuselage
?

Attach the servo arm to the ruddert servo as shown
Cut out the holes on the stabilizer
??
Finished photo.

Cut the gear plates film on the elevator
Connect the servo arm and elevator servo with ball links and pushrod
Connect the stabilizer and the fuselage with joiner

Use 3*15 screws to fix up the fuselage
Cowl
Fasten the fuel tank onto the fuselage as shown.
Install the Engine as shown
Start by installing the lower cowling half

Slide the top cowling half into position,use screw to fix it .as pictured above
Install the propeller and spinner.

Assemble Canopy as photo shown
CG POSITION & CONTROL THROWS

THE FINISHED PHOTO
Dong Guang Flight Model CO.,Ltd
DongGuan City,Guang Dong Province,China
Tel: [phone]
Fax: [phone]
E-mail:[e-mail]
Web: www.flight-model.com
http://flight-model.preview.alibaba.com/