Flight Model F126 PITTS S12 94.5" Operation instructions

Wing Span:94.5"/2400mm; Radio:10 Channel /9 servos;
Wing Area:155sq.dm; Engine:100cc;
Length:87.6"/2225mm;
CAUTION : this plane is not a toy and should be kept away
children under 16 years of age! Before use , please carefully read
this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
performance to full extent .
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.

All the
p
arts to
g
ethe
r
WING ASSEMBLY
Gather the top wing,aileron
and hinges.
Top wing installation is complet
e
Using the screw

Connect the aileron and the
lower wing by hinges.
Install the servo.as shown
Using the screw
Main Landing Gear and Tail Wheel Unit
Gather the parts for the main landing gear.

Install the wheel as shown.
Install the wheel cover,
and fix it up to landing
gear with screw.
Fix up the landing gear
on the fuselage with screws.

Install the tail landing gear
Use screws to fix up the
fuselage bottom.
Stabilizer Installation
Use a pencil to mark the
line along with fuselage.
Remove the film of the
stabilizer on both side.
Use AB glue to glue it into
the fuselage.

Finished photo
Use AB glue to fixed the
hinges of elevator and
rudder
Install the elevato
r
servo
as shown.Using the screw

Install the rudder servo
There are two installation
methods
All wing strut parts together
Connect the wing strut to
the fuselage and use
screws to fix it up

Finished photo
Gather the parts for the lower wing
Use screws to fix up the
lower wing

Fixed the lower wing and
fuselage with screws
outer strut parts,as shown
翼撑 的配件总和
wing strut screws

Finished photo
Gather the parts for the top wing
Connect the wing centre
section,as shown

Finished photo
Use flat head screw to lock
the cowl
Use PWM screw to fixed it
用PWM 固定

Install the canopy into
the fuselage as shown
Location in fuselage bottom
of fixing screws
fuselage bottom screws
Install wires into the fin
and stabilizer.

Bottom steel wire
installation as shown.
Main wing steel wire
installation as shown.
CG & CONTROL THROWS

THE FINISHED PHOTO
Another scheme for choice.Flight Model CO.,LT
D
ADD:No.10,Fu Ning Street,Xian Xi Industrial,Chang An Town,Dong
Guan City,Guang Dong Province,China
Tel: [phone] Fax: [phone]
E-mail:[email protected]
Web: http://www.flight-model.com/
Http://flight-model.preview.alibaba.com/

e