Flight Model Taylorcraft-90 Operation instructions

CAUTION : this plane is not a toy!
Before use , please carefully read this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
performance to full extent .
Outer Runner Brushless Motor:5065
Radio:6Channels 4Servos;
Flying Weight:3000g;
Wing Span:87.4in/2222mm;
Wing Area:69.2sq.dm;
Length:56.4in/1433mm;
P1

Cut away covering film for
the servo.
Install the servo to the
servo cover.
Put the servo cover in the
right position,then fixup it.
MAIN WINGS
P2

Install the servo cover to
the bottom of the wings,and
Assemble aileron、servo arm
and pushrod.
Insert the main wings with
joiner,then screw them by
nylon screws.
Assemble the plastic cover
by screws on the top of the
wings.
P3

Install the wing supports
with screws.
Make sure they are in right
positions. 3mm
The blind nuts in
the wing.
Cut off the film for the
vertical fin.
Insert the vertical fin and
glue the rudder to the
vertical fin .
TAIL WHEEL
P4

Install the tail wheel as
shown.
Cut off the film for elevator
servo installation.
RUDDER AND ELEVATOR
Adjustable
Tri-horns
P5

Install the elevator servo.
Fixup the adjustable tri-horn
then link the servo and
tri-horn with pushrod.
Inatall a servos ectention onto the elevator servo.Either
tie the srco leads together,or use a connector to secure
the extension to prevent it from coming loose during flight.
Install the motor to the four
adapter and use screws to
lock motor and adapter.
THE MOTOR INSTALLED
P6

Assemble the receiver and
receiver battery as shown.
Install two wheels to the
undercarriage as shown.
Install the undercarriage to
the bottom of the fuselage.
UNDERCARRIAGE
THROTTLE SERVO
P7

Permanently tighten the axle
to the gear strut by wrenches.
Finished photo as shown.
Install the cowling with
screws which factory provided.
CG POSITION & CONTROL THROWS
COWLING
P8

FINISHED PHOTO
P9

Tel: [phone]
Fax: [phone]
E-mail:[email protected] / [email protected]
Web: http://www.flight-model.com/product/eindex.asp
http://flight-model.preview.alibaba.com/
Guan City,Guang Dong Province,China
Flight Model CO.,LTD
ADD:No.10,Fu Ning Street,Xian Xi Industrial,Chang An Town,Dong
P10

P11

P12

P13

The blind nuts in
P14

Cut off the film for elevator
P15