Flight Model F131 Kelly F1 60 Operation instructions

Wing Span:66.9in/1700mm;Flying Weight:3000g;
Caution:this plane is not a toy!
Before use ,please carefully read this manual.
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
Radio:4Channels 5Servos;Wing Area:50sq.dm;
Length:61.8in/1570mm; Engine:2C-60,4C-91;
●First-time builders should seek advice from people having building experience in order
to assemble the model correctly and to produce its Performance to full extent.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick reference,even after
completing the assembly.

Cut away covering film for
the servo.
KIT CONTENTS
AILERON SERVO INSTALLATION

Glue the servo to prepared
servo plywood,then put the
servo into the servo hole.
Pull out the servo extention
from main wing.
Fixup the servo by the screws,
then adjust the horn and
servo arm.
Fix the horn in place firmly.

Find out the horns in each
sides of the fuselage,
then cut the film.
Insert the joiner into the
fuselage,and find the left
and right main wing in the
right position.
Fixup the wings with plastic
bolts on both sides.
Pull the servo extentions
into the fuselage from the
main wing.
MAIN WING INSTALLATION
Plastic
bolt

Find out and Cut off the
film in the bottom of the
fuselage.
Cut the film along the edge
of rectifier board .
Glue the Rectifier board
to the bottom of the fuselage.
Find and cut the hole for
stabilizer.
ELEVATOR & RUDDER SERVO INSTALLATION

Insert the U shape
wire as shown.
Assemble the elevators with
the U shape wire.
ADJUSTMENT

Apply AC glue to the hinges.
Glue the verticle fin to the
fuselage.
Assemble the elevator control
horn.
Assemble the rudder control
horn.
Rudder

Tail landing gear as shown.
Amount the alumiume street to
the tail fuselage.
Screw the wheel to the
landing gear.
Be assured that the screw
is fixed up.
MAIN LANDING GEAR INSTALLATION
TAIL WHEEL INSTALLATION
Rudder
servo

Install the wheel cover,
and fix it up to landing
gear with TP screw.
Fixup the landing gear
strut to fuselage with 3
bolts.
Line up the template with the
firewall thrust lines and
mark the location of the
engine mounting holes.
Use a drill to dill the
engine mounting holes.
ENGINE INSTALLATION

If use 4cycle 91 size.
Install the engine mount
on both sides with four
3mm screws.
If use 2cycle 60 size.
Use the same method to this
size engine.
The length from Proppler to
firework is 125MM.
Install the trottle servo
as shown.
FUEL TANK INSTALLATION

Put the fuel tank into
the fuselage, and fixup it
with belt.
Fuel tank detail assembly
picture as shown.
Install the cowling with
4pcs TP screws.
COWL INSTALLATION

Assemble the movable canopy.
Make sure it is securitly
Glue the plastic decoration
on both sides of the head.
CONTROL THROWS & CG POSITION
CANOPY INSTALLATION