Flight Model F113 YAK 54 20CC profile User manual

Assembly Manljal
F114 Sbach 342
20cc Profile
F113 YAK 54
20CC profile
F115 Extra 330SC 20cc profile
Thanks for purchasing our airplane model!
CAUTION : this plane is not a toy and should be kept away
children under 16 years of age! Before use , please carefully read
this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
performance to full extent .
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.

All the parts together
Main Landing Gear and Tail Wheel Unit
2.Gather the parts for the main landing gear.
1.Cut out the holes on the fuselage of both sides.

3.Use screw to connect the landing gear, wheel pant, nut
and wheelin turn, and finally use a lock nut to lock them.
5.Use two screws to lock the two pieces of the landing
gear to the fuselage
4.Repeat the same on the other side of the landing gear.

6.Drill a 6mm hole at the back tail of the fuselage to
install the tail wheel

Fuel Tank and Engine lnstallation
7.Put the tail wheel set into the hole, and use two pcs
self-tappingscrew to lock the tail wheel onto the fuselage tail.
2.Install the fuel tank and the fuel tubes as shown.
1.Cut out the holes for the fuselage

3.Fasten the fuel tank onto the fuselage as shown.
4.finished photo.
Standard fuel tee (built-in filter)

Main Wings Installation
5.Screw the throttle servo onto the fuselage.
Bent the pushrod, and use it to connect the servo and the engine.
1.Cut out the holes in the wings
Parts for the main wings

2. Find out the slots for the aluminum sheet.
4.Repeat the same way on the other side of the wing.
3.Use screw to lock the aluminum sheet onto the wings.

5.Stick a velcro tie into the holes in the back of the wing
as shown.
7. Find out the cover plate of this hole
6. Stick the battery onto the white velcro tie.

8. Fix the plate onto the back of the wing by screws.
Repeat the same on the other side of the wing to
install the receiver.
Install the winglet as shown

Tail Part Installation
1.Use AB glue to glue it into the fuselage.
3.Gather the parts for the main landing gear.
2.Cut out the holes on the fuselage of both sides.

4.Remove the covering film at the postion for the stabilizer.
5.Use a saw to cut off the part at the end of the fuselage.

6.Insert the fiberglass control horn sheet into the aileron hole
pre-cutted.Use AB glue to glue it.
8.Install the ball links onto the servo arm and the control
horn with stainless push rod supplied.
7. Screw the servo with 4 pieces self-tapping screw.

9.Insert the fiberglass control horn into the elevater, and glue
with AB glue Screw the elevater servo onto the fuselage as shown.
10.Connect the control horn and elevater servo with ball links
and pushrod.

3.Insert the fiberglass control horn into the rudder, and glue
with AB glue Screw the rudder servo onto the fuselage as shown.
2.Cut out the holes in on the other side of the fuselange
forthe rudder servo.
1.Cut out the slot for the rudder control horn as shown.

4.Connect the control horn and rudder servo with ball
links and pushrod.
THE FINISHED PHOTO