Flight Model Funtama 100 Operation instructions

CAUTION : this plane is not a toy!
Before use , please carefully read this manual.
●First-time builders should seek advice from people having building
experience in order to assemble the model correctly and to produce its
●Assemble this kit only in places out of children’s reach!
●Take enough safety percautions prior to operating this model.
You are responsible for this model’s assembly and safe operation!
●Always keep this instruction manual ready at hand for quick
reference,even after completing the assembly.
performance to full extent .
Engine:26-28CC GAS;
Radio:4channels 5servos;
Flying Weight:3600g;Wing Span:70in/1780mm;
Wing Area:61sq.dm;
Length:62.9in/1600mm
P1

KIT CONTENTS
P2

Connect the aileron and main
wing with horns.
The finished picture as shown.
Pay attention to glue firmly.
Cut away covering film for
the servo.
MAIN WINGS
AB GLUE
P3

Install the tri-horn and
servo arm with pushrod
as shown.
Measure the length of the
extention .
Pull out the extention from
the rib of the main wing.
P4

Find out the holes in
each sides of fuselage,
then cut the film.
Connect the main wings and
the fuselage with joiner.
Also pull the extension
into the fuselage.
Fixup the wings with nylon
screws as shown.
P5

Install the wheel with
screw and collars as shown.
Fixup the wheel to the
landing gear by screw.
Use two TP screws to fix
the wheel cover to the
landing gear.
MAIN LANDING GEAR
P6

Install the main landing
gear on the bottom of the
fuselage.
Find and cut the hole for
stabilizer and also the
servo holes.
Cut away the film along
the edges, and glow the
stabilizer to the fuselage.
TAIL WHEEL
P7

Cut the rudder film along
the edges, and glue the
rudder to the fuselage.
Securely glue up and
soaked up the hinge with
instant glue.
Bend the tail landing
gear to fit for the rudder
and insert it into the
rudder.
P8

Glue the rudder to the
fuselage.
Glow the tail landing gear
to the rudder securely.
Install the tail wheel,
and fasten the presser
of the tail wheel to the
stabilizer by screws.
P9

Insert elevator to the
tailplane with U shape wire.
Connect the control horn
to the linkage of the
servo.
Tighten the second loop
through the brass swage
tube.
ELEVATOR AND RUDDER
A
B
P10

Crimp the brass tube with
a crimping tool or pliers.
Connect the parts as shown.
Rudder
servo arm
Push
rods
P11

Install rudder pushrod.
Gather the MLD engine and
spare parts as shown.
The finished picture as shown.
Pay attention to:you have DLE and MLD for choice.
ENGINE
P12

Install the DLE 30CC as shown.
P13

Place the hatch.
Use two screws to secure
it firmly.
FUEL TANK
P14

CG POSITION & CONTROL THROWS
MEASUREMENT
P15

Flight Model MFG CO
.
E-mail:[email protected] / [email protected]
Web: http://www.flight-model.com/product/eindex.asp
http://flight-model.preview.alibaba.com/
ADD:No.10,Fu Ning Street,Xian Xi Industrial,Chang An Town,Dong
Guan City,Guang Dong Province,China
Tel: [phone]
Fax: [phone]
FINISHED PICTURE
P16