Fluke COMARK Diligence RF313-TH Guide

Part No: 20632-1 03/19 Page 1 of 3
Restart or Factory Reset a WiFi Device
This Help Guide refers to Diligence™ WiFi data loggers, including Sensors and Alert
How do I Restart or Reset my Diligence™ WiFi data logger?
Under normal circumstances, you do not need to reset your Diligence™ WiFi data logger. However
you may be instructed to do this by our support team to recover a Device which is not working
properly, or return it to its factory state.
Restart
Performing a Restart on the WiFi Sensor will restart the internal firmware, retaining all configuration
and network settings. The Sensor will disconnect from the wireless network, and immediately enter
a low power sleep mode. It can take up to 30 minutes for the Sensor to re-connect and synchronize
after a Restart. Under normal circumstances the Sensor will synchronize within 15 minutes. Once
communication is re-established the Sensor returns to its normal transmission rate. A Restart will
cause a new recording session to be started.
To perform a Restart...
What is this?
RF313-TH
From the Sensor Home screen
Press and hold the button for 10 seconds
Release when the LOW symbol starts to flash.
All other Sensor types
RF311-T, RF312-TP, RF312DualPlus,
RF312Glycol, RF314-TC, RF314Dual
From the Sensor Home screen
Press and hold the button for 10 seconds
Release when the LCD shows

Part No: 20632-1 03/19 Page 2 of 3
Restart or Factory Reset a WiFi Device
Factory Reset
Performing a Factory Reset on the WiFi Sensor will clear all internal configuration and network
settings. The Sensor will disconnect from the wireless network, and all WiFi activity is stopped. When
you want to use your Sensor again, you’ll need to connect the Sensor to a wireless network and re-
configure it using the WiFi Sensor Software.
You should perform a Factory Reset prior to shipping the Sensor or before storage.
To perform a Factory Reset...
RF313-TH
From the Sensor Home screen
Press and hold the button for 20 seconds
Release when the LCD shows
WiFi-AL (Alert)
Press and hold the button for 10 seconds
Release when the LEDs start to cycle.

Part No: 20632-1 03/19 Page 3 of 3
Restart or Factory Reset a WiFi Device
All other Sensor types
RF311-T, RF312-TP, RF312DualPlus,
RF312Glycol, RF314-TC, RF314Dual
From the Sensor Home screen
Press and hold the button for 20 seconds
Release when the LCD shows
RF324 Alert
Press and hold the button for 20 seconds.
The LEDs will cycle. When the LEDs go out, release the
button.