Fluke TS 44 PRO Parts list manual

PN 2749020
October 2006
©2006 Fluke Corporation. Printed in China.
TS®44 PRO Test Set Users Card
Data Test
Connect the unit to Tip and Ring and move the T/M
switch to T. If high speed data is present, the unit’s
alarm will start beeping and the unit will lockout
and not go off-hook. If there is no high speed data,
the unit will go off-hook.
Data Lockout Override
In Talk mode, while the data lockout alarm is
sounding, press the OVERRIDE key – the unit will
go off-hook. For example, this is what you would
do to access POTS on a line carrying both POTS and
ADSL.
Line Voltage Test
In Monitor mode, press Vdc&mA/TEST key.
Low Voltage
0 Vdc to 2 Vdc - LO LED lights up red for 3 sec-
onds.
2 Vdc to 42 Vdc - LO LED flashes red.
Normal Voltage
42 Vdc to 53 Vdc - LO and HI LEDs flash green
once.
High Voltage
53 Vdc to 140 Vdc - HI LED flashes red.
>140 Vdc - HI LED lights up red for 3 seconds.
Loop Current Test
Go off-hook and press the Vdc&mA TEST key.
If the loop current is less than 23mA, the mA LED
flashes red. If the loop current is greater than
23mA, the mA LED flashes green.

TS®44 PRO Test Set Users Card
Redial the Last Number Dialed
Go off-hook and press the LNR key.
Pulse Dialing
By default the unit is configured to Tone dial. But if
you want to Pulse dial, go off-hook and press the
TONE/PULSE key, now the unit will pulse dial.
Program Speed Dial Numbers
In Monitor mode, press RCL. Enter the number to
be stored. Press STORE/PROG, then press the num-
ber of the memory location (0-9) where you want
to store it. The confirmation tone sounds.
ToSpeed Dial a Stored Number
Go off-hook, press RCL, then press the key (0-9) of
the memory location where the number is stored.
Two-Way Speakerphone
While off-hook, press SPKRtoactivate. Press SPKR
again to deactivate. If you are listening only, press
MUTE to activate the Receive-Only Loud Speaker.
Press MUTE again to restore the two-way Speaker-
phone.
To Set Receive-Only Loud Speaker as
Default
1Put the test set in Monitor mode.
2Press STORE/PROG.
3Press MUTE. The confirmation tone sounds.
To restore the Speakerphone as the default
Speaker mode, repeat the three steps above.