Fly Sky FS-BS6 User manual

Digital Proportional Radio Control SystemFS-BS6
Receiver Overview
Connectors
Used to connect to the model and servos.
The FS-BS
４
receiver has a gyroscope SVC function that can be used to improve handling.
Binding
1.
Insert the bind cable into the receivers BIND port;
2.
Plug the power cable into any other port, and the receiver's LED will start to flash quickly indicating that it
has entered bind mode.
Status Indicator
The status indicator is used to indicate the power and working status of the receiver.
• Off: The power is not connected.
• Lit in red: The receiver is on and working.
• Flashing quickly: The receiver is binding.
• Flashing slowly: The bound transmitter is off or signal is lost.
Antenna CH 1-6
Bind/VCC
LED
FS-BS4
• CH1 to CH4: used to connect the servos, power or other parts.
• BIND/VCC: used to connect the bind cable for binding, and the power cable during normal operation.
• SERVO: used to connect i-Bus module and extend channels.
• SENS: used to connect all kinds of sensors.

Digital Proportional Radio Control SystemFS-BS6
FS-BS4
ＦＣＣ ＩＤ：２Ａ２ＵＮＢＳ４００
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Warning:changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and
your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
FCC compliancestatement