Fomei Digitalis Pro 200S User manual

Studio flash
Digitalis Pro
200 / 400 / 600 S

Thank you for your confidence in our company and wish you much success in your projects.
Safety precautions
-Do not use the product before reading the manual
-Do not expose the moisture
-Do not try to disassemble the product
-Do not expose the product to the electromagnetic field
-Do not expose the product to big variations in temperature in humid environment.
Inside could condense water
-Do not use studio flash head without flash tube protecting glass
Package contents
Digitalis Pro S power cable sync cable 300W pilot bulb
Specification
Model
200S
400S
600S
Lamp output (Ws)
200
400
600
Flash colour
temperature (K)
5500
5500
5500
Pilot bulb colour
temperature (K)
3200
3200
3200
Flash duration (sec.)
1/4000
1/2300
1/1700
Flash charge (sec.)
1.1
1.1
1.2
Weight (Kg)
2.1
2.3
2.6
Dimensions (mm)
276 x 120 x 255
276 x 120 x 255
337 x 120 x 255

Components
1) Glass cover of lamps
2) Modeling lamp
3) Flash tube
4) Modeling lamp bayonet
5) Accessories bayonet lock
6) Light sensitive sensor for cell mode (slave mode)
7) Joint for adjusting light angle

8) FND display
9) 220V power cable input
10) Fuse socket
11) Sync cable input
12) Power (on/off)
13) Slot for receiver
14) Light sensitive sensor for cell mode (slave mode)
15) Control panel functions

Controls
1) Connect the power cable into power grid
2) Put the receiver into flash head socket
3) Turn the light on
4) Set up the light intensity and other function by instructions below
Modeling lamp / flash settings
Intensity adjustment by 0,1 or 0,5 steps
Proportional adjustment of modeling lamp and flash a tone (on / off)
Light sensitive sensor activation (slave mode)
Flash is charged and ready - sound signal (on / off)
Flash test