Forever Redwood BACKLESS BAR STOOLS User manual

Backless Bar Stools www.foreverredwood.com
866.332.2403 (Toll Free), 7am-7pm Pacific Time, Monday-Saturday
Assembly instructions for:
BACKLESS BAR STOOLS

Backless Bar Stools www.foreverredwood.com
ASSEMBLY INSTRUCTIONS
CONTENT OF THE BOXES
The parts that go together have the same numbers written next to the predrilled holes they attach to.
Align the parts with the numbers as shown for ease of reference
Tools required: ½-inch ratchet and a mallet or small hammer.
1. Turn seat upside down. You’ll notice that each corner has a
number that corresponds to each leg. Match the leg number to the
corner hole and attach with one carriage bolt. Align the predrilled
holes, lightly tap the bolt in. The bolts should tap into their holes. If
you have to force a bolt, the leg is probably not oriented properly, is
in the wrong hole or it is turned around. Make sure the bolts are
tapped all the way into the wood, then add washers and nuts and
tighten with a ½-inch ratchet. Do not over tighten or you’ll crush the
redwood and weaken the table’s structure.
2 Attach the cross supports to the legs
as shown. Just match the numbers to
the pre-drilled holes and attach with
one carriage bolt.