Sunjoy Monterey User manual

10'X12' Monterey gazebo instruction manual
Item #: L-GZ215PST-4
SKU #: 210019492

IMPORTANT:
Please read and follow all safety statements, warnings, assembly instructions, use & care directions before
attempting to assemble.
1. When installing and assembling your gazebo, it is recommended that 2 or more adults are involved.
2. Do not use the unit during an electrical storm, as there is a remote chance of getting struck by lightening.
3. Do not climb on top of the gazebo. Falling off the gazebo can result in serious injury, possibly even death.
4. Do not leave the gazebo assembled when there is a risk of high wind, as possible damage will occur to the
structure.
5. Never barbecue under this gazebo or use lanterns that contain naked flames.
6. This package contains small items and plastic bags that should be kept away from children.
7. Ensure that all connectors & poles are firmly secured in position fully. It is important to do so before use so
as to avoid collapsing or damage to the item, which could result in injury.
8. WARNING: Keep all flame and heat sources away from this tent fabric. This tent is made with fabric that
meets CPAI – 84 specifications for flame resistance. It is not fire proof. The fabric will burn if left in continuous
contact with any flame source. The application of any foreign substance to the tent fabric may render the
Flame-resistant properties ineffective.
9. WARNING: Please take down the gazebo during strong wind. The manufacturer or retailer is not liable for
any loss of the product or other items due to the failure to take down the gazebo during strong wind.

Pole 1 A 4
Base B 4
Base cover C 4
Short beam 1 D 2
Short beam 2 E 2
Long beam 1 F 2
Long beam 2 G 2
Corner connector 1 H 2
Corner connector 2 I 2
Side beam connector J 4
Connector K 4
Big top beam L 4
Short side beam M 2
Long side beam N 2
Long mosquito pipe O 4
Small mosquito pipe P 4
Big top connector Q 1
Small top connector R 1
Small top bar S 4
Small canopy T 1
Large canopy U 1
Privacy panel V 1
Mosquito netting W 1
Hook X 1
Parts List

AA M6X15 Bolt 40 PCS
BB M6 Flat washer 72 PCS
CC M6X15 Bolt 24 PCS
DD M6X20 Bolt 8 PCS
Z M6 Wrench 1 PC
Hardware Pack 1

Fig.1: Put the Base cover (C) on the bottom of Pole (A), then use Bolt (AA) and Flat washer (BB) to connect
the Base (B) and Pole (A). Note: Make sure the slots on (C) and (A) are at the same side.
Fig.2: Connect the Beam F (D) and Beam G (E) by using the bolt (CC) and Flat washer (BB).
Fig.3: Attach the connected Beam to stand Pole (A) by using Bolt (CC) and Flat washer (BB) then use Bolt
(AA) and Flat washer (BB) to fix the beam and stand pole tightly.
Fig.4: Attach Mosquito pipe O (N) to Beam by Bolt (AA) and Flat washer (BB).
Fig.5: Attach Connector (K) to Short beam E (D) and Long beam F (G) by DD and BB.
Fig.6: Attach Side beam connector (J) to Beam by Bolt (AA) and Flat washer (BB).
AA M6X15 Bolt 8 PCS
BB M6 Flat washer 24 PCS
EE M6X40 Bolt 8 PCS
FF M6 Nut 8 PCS
Hardware Pack 2

HH Φ8X260MM Peg 16 PCS
GG Plastic tie 104 PCS
Hardware Pack 3
Fig.7: Attach Corner connector (H) to Pole (A) by using Bolt (AA) and Flat washer (BB).
Fig.8: Hang up the Hook (X) to Big Top Connector (Q). Then Insert Big top beam (L), Long side beam (N)
and Short side beam (M) into Big top connector (Q).
Fig.9: Insert Big top beam (L) into Corner connector (I).
Fig.10: Attach Side beam M (N) to Side beam connector (J) by Bolt (EE), Flat washer (BB) and Nut (FF).
Fig.11: Insert Small top bar (S) into Small top connector (R). Put on the Small canopy (T).
Fig.12: Put on the Large canopy (U), do not spread. Attach the small top to Big top beam (L) by Bolt (EE),
Flat washer
(
BB
),
Nut
(
FF
)
.

Fig.13: Hanging Mosquito netting (W) to Mosquito pipe P (O) by Plastic tie
(GG).
Fig.14: Hanging Privacy panel (V) to Mosquito pipe O (N) by Plastic tie
(GG).
Fig.15: Put up the Base cover (C), using Stake (HH) to fasten the gazebo.

USE & CARE
1. This Gazebo is not a permanent structure and should be disassembled & stored away after use.
2. Do not repack your gazebo until completely dry.
3. This Gazebo must be assembled by two adults or more.
4. This Gazebo must not be left erect in windy conditions.
WARNINGS
1. Assembly Instructions must be followed.
2. Pegs supplied must be used to hold this gazebo in place when upright.
3. Warranty does not cover damage due to extreme weather conditions.
CUSTOMER SERVICE
Sunjoy Industries warrants to the original purchaser that this item is free from defects in workmanship and
materials of your item provided the item was factory-sealed at the time of purchase and is maintained with
care and used only for personal, residential purposes. The item is warranted to be free from defects in
material or workmanship for a period of 6 months. Should any manufacturing defect arise within this warranty
period, Sunjoy Industries will repair or replace (at our option) any defective merchandise upon proof of
purchase; however, transportation and delivery costs, as well as labor and material charges to remove or
replace parts, remain the responsibility of the purchaser. A purchaser of an "open box," previously-returned,
or "clearance" item, as well as original purchasers outside of the warranty period, may obtain replacement
parts from Sunjoy Industries for products in current production, at nominal cost.
If you are within the return policy that most stores have, you do have the option of returning this item back to
the store which you bought it from for an exchange of the same item, or a refund of the purchase.
If you are within or beyond the return policy that most stores have, and need tech. assistance or replacement
parts, please call Sunjoy Industries at 1(866) 578-6569 from 8:30 am to 5:30 pm eastern standard time or
e-mail to [email protected] or fax your parts replacement order form together with the purchase
receipt to 1 [phone] for assistance.