Fox-Lux FXD02 User manual

3 hour
Self
Test
Installation, Maintenance and Servicing Notes
TESTING
Ensure this product is disposed
responsibly according to WEEE
directive 2002/96/EC
Warning: never put this luminaire inside its box
when it is in emergency mode. The luminaire can
get damaged due to heat not being able to
escape. To avoid this please disconnect and re-
connect the battery before putting the luminaire
back in the box.
40
30
25
82
IP
20
IP
54
Front Back & LED driver
230
FXD02 LED EMERGENCY DOWNLIGHT
Thank you for purchasing our FXD02 LED Emergency Downlight.
Our products have been designed according to the relevant standards. If installed and maintained
correctly they will provide a long service life.
BS EN 60598-1 / BS EN 60598-2-22 / BS EN 50172 / BS EN 1838 / BS EN 62034 / ISO 7010 / ISO 3864
•Ensure that the mains supply is switched off before installing, maintaining or servicing the luminaire.
•Luminaires should only be installed by qualified personnel.
•The LED light source and control gear are non-replaceable. Once end-of-life is reached, the
luminaire should be replaced.
•In case of mains supply failure, the battery will automatically energise the emergency light for a
minimum 3hr period. After 3hrs 5m the luminaire will enter standby
mode to protect the battery from over-discharge. The battery must be
recharged within 6 months of full discharge.
•Self-test emergency luminaires are programmed to carry out
functional and full duration tests according to BS EN 50172:2004.
•First battery charge will take up to 16hrs.
•Battery re-charge takes up to 8hrs. Note that full cycle (discharge and
recharge) takes up to 12hrs.
•Contact Fox Lux if a replacement
battery is required.
•Warranty terms apply. See website for details.
Standard
Self-test
Functional test is carried out automatically once a week and runs for 30s. Full duration test is carried
out automatically every 52 weeks. First full duration test is carried out automatically within the first
4 weeks after the luminaire being connected to mains.
This luminaire can be used with the optional Remote Control (REM10) which adds extra features to
Fox Lux emergency luminaires. Please refer to the REM10 user g uide.
Testing and commissioning must be carried out manually according to BS EN 50172:2004.
LED Status Indications
Normal flash = 1Hz (once/second)
Fast flash = 2Hz (twice/second)
Solid ON
Normal Flash
OFF
Fast Flash
Normal Flash
OFF
OFF
OFF
Solid ON
OFF
Normal Flash
Normal Flash
OK
Charging
Battery disconnected /
Duration test failure
Functional/Duration test in progress
Battery temperature
Light source fault
Connect battery /
Replace battery
Contact Fox Lux
Replace luminaire
GREEN LED RED LED Green Red STATUS ACTION REQUIRED
t | [phone] | e | [email protected] | w | www.fox-lux.co.uk
Registered Office: Alex House 260/8 Chapel Street, Salford, Manchester, M3 5JZ
Company Registration No. 11821284 VAT Registration No. 320 9921 12

Min. 110mm
Ceiling void
This product is Class II insulated.
Earth connection not required
Cut-out 50mm
Ensure that the mains supply is switched off Before
installing, maintaining or servicing the luminaire.
1: Isolate mains 2: Ceiling cut-out 3: Cable size and strip length
4: Connect mains 6: Complete labels
7: Restore mains supply
0.75 -1.5mm2 8+1mm
N
L
5: Install luminaire into ceiling
110mm
Blue
(Permanent)
Brown
N
L
Part.No.:
Input voltage: 220-240V AC 50Hz
X 1 180
Installation date: __ / __ / ____
Part No.: 3.6V 5000
Secondary Li-ion Battery Pack
Li18650-5000mAh
3.6V 5000mAh 18Wh
1ICR19/66-2
Mfg date:
Installation date: / /
MAX Downlight range
Ref. Description Operating
temp. ta
Net
weight
Remote Control
Testing
Installation Guide:
0°C - 40°C 0.25kg
FXD02-3/O/3
FXD02S-3/O/3
Recessed LED Downlight 3hr NM 270lm - Open Area Lens
Recessed LED Downlight 3hr NM 270lm - Open Area Lens SELF-TEST
Manual
Self-test
REM10
REM10
FXD02 Emergency LED Downlight
Secure mains cable using
cable clip and screws supplied
*Remote Control REM10 allows the competent user to carry out functional tests and/or full duration tests at any time and to check system status. Please refer to REM10 user guide.
-Enter installation date on battery label
-Enter the appropriate code on the luminaire label
lssue V1: 5/1/2020
t | [phone] | e | [email protected] |w| www.fox-lux.co.uk
Registered Office: Alex House 260/8 Chapel Street, Salford, Manchester, M3 5JZ
Company Registration No. 11821284 VAT Registration No. 320 9921 12