Frama KR-180 User manual

KR-180 DAYBED
Designed by Kim Richardt

CONTENTS:
In this box you will find:
- 4 screws
- 8 wooden dowels
- 4 legs
- 2 horizontal cross support
- 2 bed support frames
- 18 bed supports
- 1 umbraco tool
KR-180 DAYBED ASSEMBLY GUIDE
4
3
2
5
44
1

KR-180 DAYBED ASSEMBLY GUIDE
Start by unpacking wooden dowels from package 5 and placing
the dowels in each of the outer holes located on the top of the
leg pieces, located in package 3

KR-180 DAYBED ASSEMBLY GUIDE
Next remove the horizontal cross supports in package 3.
Using one horizontal cross support at a time, fasten each leg by
fitting the wooden dowels with the two outer holes located on
the horizontal cross supports. Repeat on the other side of the
horizontal cross support, and then with the second horizontal
cross support.
1
3
4
2

KR-180 DAYBED ASSEMBLY GUIDE
Next remove the two bed support frames in package 1. Align
each bed support frame with the center hole located in each of
the now attached leg and two horizontal cross support frames.
Screw the four screws located in package 5 in place using the
small umbraco tool also located in package 5.
1
3
4
2

KR-180 DAYBED ASSEMBLY GUIDE
Place all bed supports located in package 4 within their allo-
cated slots atop the bed frame.

NOTE:
End grain (edges), should by treated extra frequently to avoid dryness and cracking in the
dry season (winter). Irregular distribution of moisture in the wood can cause unnecessary
cracks and gap. To avoid this we recommend oiling both the top and underside of the
furniture.
CLEANING & MAINTENANCE
CLEANING WOOD:
CLEANING MATTRESS:
Daily cleaning of wooden base is done with a soft cloth wrung out in clean water. Avoid
using
cleaners containing any type of chemicals on the furniture.
1. Clean the furniture using a clean cloth dampened with warm water.
2. Once the furniture is dry, apply oil to a clean soft cloth or sponge - do not pour the oil
directly
on the wood
3. Rub the oil into the wood in the direction of the grain, treating the entire surface of the
furniture piece.
4. Let the oil soak for about two hours, then remove any excess oil with a soft clean dry
cloth.
5. Rub the surface with a clean soft cloth until a uniform surface is obtained, then let dry.
Linen Matress with Cold foam interior : Dry-clean or cold delicate
wash recommended. Do not bleach.

Org. St. Pauls Apotek - Fredericiagade 57 - Copenhagen - Denmark