Franke FTU 3807-P XS 70H User manual

All the instructions or operations described here are to be to be carried out on the
Hood control panel
To begin the hood should not have a mains electrical supply connected, though if the
switch supply point is not close enough to the hood, and in a remote location, that cannot
be physically be reached by the operator the while at the hood, then help will be required
to further complete this instruction.
To enter the parameter to activate the remote control,
1) Hold down the minus button (-) on the hood control fascia, while switching the
power supply on at the socket.
Display will show ‘SO’ then ‘SE’(immediately release the minus (-) button.)
2) When ‘SE’ displays immediately release the minus (-) button.
Display shows ‘Rotating squares’
3) Now press and hold for two (2) seconds the 24 hr button. Just once.
Be aware that further depresions of this button will deactivate the remote control.
4) The display window will show twice!
The remote control is now active,
NB Please note the following:
i. There is no visible sign from the remote control, of infrared operation, from the
users point of view. No flashing lamp.
ii. The activation of a hood function by remote control, may take several (approx 5)
seconds to be decoded by the hood. Keep the selected function button on the
remote control pressed. Unlike a television remote control that gives instant
results at the touch of a button. Please be patient.

For infrared operation there must be a clear line of sight between the remote control and
the hood control fascia, or display, or other receiver as described in the user instruction
book.
Only two operations can be selected from the remote control when the hood is off.
1) The 24 hour function can be activated, press and hold the button for
approximately 3 seconds.
The display will show 24 and the fan operate for a few seconds confirming the
setting.
The appliance can be switched on.
2) To switch ‘on’press and hold the button on the remote control. until the
operation starts. With the appliance switched ‘on’ all the remote control buttons
are now operational to control the hood functions.
3) Switch Off
To switch ‘Off’ press and hold the button on the remote control. until the
operation starts.