Freedom Innovations Kinnex 2.0 User manual

©2019 Freedom Innovations, LLC. All rights reserved. Kinnex is a trademark of Freedom Innovations, LLC. CG-03-010 Rev. A Kinnex 2.0 Prosthetist Setup Guide
FREEDOM INNOVATIONS
Global Headquarters
3 Morgan
Irvine CA 92618
toll-free 888.818.6777
tel [phone]
www.freedom-innovations.com
For more information, consult
the Instructions for Use Manual or
call 888.818.6777.
10
11
Follow the instructions in the App to adjust resistance settings in the ankle for plantar exion, dorsiexion and toe stiness. For each re-
sistance change, sliding the setting to the left will decrease resistance or stiness and sliding the setting to right, will increase resistance
or stiness. Adjust until optimal setting achieved.
Follow next screens to demonstrate Low Battery, Dead Battery mode, and Manual Lock.
Prosthetist
Setup Guide
Alignment and Setup
™
9
Connect with us
#freedomeveryday
Setup: Allows prosthetist to go through Full Setup Process, or individually Calibrate, Adjust
resistance settings, or demonstrate to the patient the dierent modes available
Disconnect: Allows prosthetist to disconnect from ankle or unpair the ankle and disconnect
Tools: Allows prosthetist to generate cadence report, update rmware or reset to factory defaults
Status: Shows ankle connected, battery status, total steps, serial number, part number and rmware
version
Help: Provides contact information for technical support
2.0
The tool bar across the bottom of the screen provides short cuts to the dierent functions of the ankle.

FREEDOM INNOVATIONS
Download the GaitLab App from the iTunes store for iOS
devices or the Google Play store for Android devices.
Press and hold the Bluetooth
Button on the ankle until the
blue light starts blinking. This
will enable “Clinician Mode”
and will not allow the Kinnex™
App to connect. (Figure 1)
1
2
3
Prosthetist Setup Guide
GaitLab App
Open GaitLab App and tap “Connect.” Tap the serial number
of the ankle to connect. (Figure 2)
Figure 2
Figure 1
Prosthetist Instructions
™2.0
Figure 3
Figure 4
Once connected to the ankle, the blue light on the ankle will turn solid.
When connecting with GaitLab for the rst time, a pop-up window
will appear requesting an authorization code to be entered. Enter the
authorization code provided with Kinnex (This can be found on the
reverse side of the introduction card located in the top foam layer of the
Kinnex packaging). Then press and release the Bluetooth Button on the
ankle when prompted to pair the ankle and the device. This process
is a one time procedure that authorizes this mobile device with any
Kinnex ankle.
Once connected, you will see the Setup screen. (Figure 3) Tap “Full
Setup” and continue to the “Alignment” screen to complete your bench
and static alignment
Adjust the angle of the Kinnex until it locks in the neutral position (90˚ with a
3/8” heel height).
Alignment recommendations : Plumb line through the bisected socket should
fall through the anterior dome of the pyramid or up to 1.5 cm anterior to this
point as shown here. (Figure 4)
Once bench and static alignment are complete, continue through the
remaining steps to program the ankle.
8
4
5
6
7
n n
1.5cm