Step 1: Set up Receiver
• Connect antenna
• Open and screw in table stand
• Connect power cord
• Turn main power on
Step 2: Set up Transmitter and Charger
• Insert batteries into transmitter
• Connect power cord to charger
• Place transmitter in charger and charge overnight
• Note: red “charging” light on charger should be on
Step 3: Match Transmitter and Receiver Channel Numbers
You can use two transmitters simultaneously with
your ToGo system as the receiver has two
receiving channels, A and B.
• Match the channel number on the first
transmitter to the Channel A channel
number on the receiver (e.g., 41)
• Match the channel number on the second
transmitter to the Channel B channel
number on the receiver (e.g., 51)
Step 4: Turn on Transmitter
• Connect microphone to transmitter
• Turn on transmitter
Step 5: Turn on Receiver
• Turn receiver Channel A or B on
and adjust volume
Step 6:
• Low: use in low noise environments for
the most natural voice reproduction
• Mid: use in moderately noisy environments to
increase emphasis on mid and high speech frequencies
• High: use in noisy environments to optimize
mid and high speech frequencies for maximum
speech intelligibility
Step 7: Connect CMBT Bluetooth®Audio Receiver
• Attach the supplied rubber feet to the bottom of the CMBT
receiver and select a stable space near the 925RS
• Connect the supplied power source to the 5VDC jack of the CMBT
and plug the supply into an electrical outlet
• Plug one of the supplied 3.5mm audio cables into the Bluetooth Audio
Out jack on the CMBT and connect the other end to one of the available
audio inputs on the 925RS.
A
B
Step 6
Step 4
Step 3
Step 2
Step 1
Step 5
LOW
MID
HIGH
Ch. A
Ch. B
Microphone
input
Step 7
(optional)
Optional
