FS FS-NVR-36CH User manual

Quick Installation Guide
Network Video Recorder
Thank you for using our product, please read
this manual carefully before use.
FS019 V1.0
January 2017

Item List
Item Name Quantity
1 Mouse 1
2 CD 1
3 Power Adapter 1
4 Quick Installation Guide 1
5 Network Video Recorder 1
Specifications
25CH 36CH
Operating System LINUX LINUX
Compression Standard Standard H.264 H.265/H.264
36CH
(4K, 5MP, 4MP, 3MP, 2MP, 960P, 720P,
etc.)
HD Output 1CH,HD port; resolu-
tion: 4K/1080P/720P, etc
VGA Output 1CH, VGA port; resolu-
tion: 4K/1080P/720P, etc
Preview Resolution single channel for the IPC main stream,
multi channel for sub stream
Video Frame Rate PAL: 25 frames/sec; NTSC: 30
frames/sec.
Local Playback 4K@4CH
Backup USB, network backup USB, network backup
Hard Disk Two SATA hard drives (maximum 8TB) Two SATA hard drives (maximum 12TB)
Network Interface 1 RJ-45 port(10/100/1000Mbps) 1 RJ-45 port(10/100/1000Mbps)
Support Mobile iPhone, iPad, Android iPhone, iPad, Android
Browser IE8.0 and above, Firefox, Google IE8.0 and above, Firefox, Google
Support Agreement ONVIF 2.4 ONVIF 2.4
USB Interface 2-USB2.0
Multi operation
Support for recording, playback,
network, backup, mobile monitoring and
interface operation
Support for recording, playback,
network, backup, mobile monitoring and
interface operation
Operating Voltage DC 12V DC 12V
Operating Temperature -10℃—55℃-10℃—55℃
Humidity 10%～90% 10%～90%
Power Consumption ≤ 60W ≤ 60W
IPC Input
Model
--
-
5MP, 4MP, 3MP, (1920×1080, 1280×960,
1280×720 etc.)
1CH，HD port;
resolution:1920x1080P/60Hz
1CH，VGA port;
resolution:1920x1080P/60Hz
25CHxD1/16CHxD1/9CHxD1/4CHxD1/
1CHx1080P
PAL: 25 frames/sec; NTSC: 30 frames
/sec.
4x1080P
2-USB2.0/1-USB3.0

1. Product Appearance Introduction
Rear Panel
Front Panel
Name Function Name Function
ENTER Enter the main menu 9 Channel switch
USB USB storage devices
ALARM Often bright when
alarming
HDD Steady light when the
HDD works
Interface Name Interface Function
1 Ethernet
2 VGA output
3 HD output
4 USB 3.0
5 Power input
6 The power switch
Note：The appearances of product, including buttons,
interfaces and layout, are for reference only, and the actual
delivered goods shall prevail.
ENTER
4
9
ALARM NET HDD
HD
VGA
AUDIO OUT
AUDIO IN
OFF
ON
DC 12VC
=
1234
5
6
4 Channel switch
NET Steady light when connects
the network cable

2. Hard Disk Installation
3. Local System Login
Take the following model as an example
hard
①Loosen the screws on the base plate. ②Align the screw holes on the hard
disk with screw holes on the base plate.
③Turn the device and use screws to
tighten the hard disk to the bottom.
HDD
After the normal startup, click the right mouse button and there
will be a login dialogue. Then enter the user name and password
in the input box. In the factory default state, the user name is
admin, and the password is 12345. Admin is the default
high-privileged user.
④Plug in the hard drive cable and power
cable.

4. Web Login
5. Connection with the IPC
2 ↑4 ↑
3 ↓Select search to the camera
5 →
1
Right-click in the main
If the plug-ins cannot be loaded, you need to set IE as follows:
Tools→ Internet Options → Custom Level → ActiveX controls
and plug-ins, to enable all, and click OK.
Enter the IP address of the recorder in the browser address bar,
and connect. After a successful connection, it will pop up an
input box as shown below.
Enter the user name and password. The factory default
administrator user name is admin, password is 12345.
Note: Make sure the NVR and IPC are in the same LAN, but
different IP address.
interface

Copyright Statement
No part of this manual shall be copied, reproduced, transcribed or
translated in any form or by any means without the prior written
consent of FS.COM. Product specifications and information
mentioned in this manual are for reference. Any updated information
shall not be announced. Copyright© 2009-2016 FS.COM. All Rights
Reserved. All statements and information does not constitute any
form of guarantee. FS trademark and FS logo belong to FS.COM.