FS M6200 Series User manual

V4.1
󾙘󾙔󾙒󾙒
PLATE-FORME DE LA SÉRIE M6200

M6200 SERIES PLATFORM

NOTE: This power cord cannot be used with other devices, and other power cords should
not be used with this device.
M4 Screw x8 (2U)
M4 Screw x12 (5U)

Front Panel LEDs
LEDs
ALM
RUN
IN
OUT
Input Optical
Power Alarm
Module RunSlow Flash
Always Green
Always OFF:
The module is not normally enabled.
Always Red:
The is a LOS alarm occurs at the port.
Always OFF:
The port is not enabled.
Module State AlarmLight OFF
Always ON:
There is an alarm of the power supply,
the fan or the NMU module.
Quick Flash:
The module type does not match.
DescriptionNormal State
Alarm State

Front Panel Ports
LEDs State Description
SYS
Slow Flash of Green Light There is no alarm of the module.
The module type does not match.
There is an alarm of the module.
The module is enabled.
There is no LOS alarm of the port.
There is a LOS alarm of the port.
The port is disabled.
Quick Flash of Red Light
Slow Flash of Red Light
Always Red
Always Green
Always Red
Always OFF
1~10
Ports DescriptionPort Type
Port 1~10 Optical Transceiver Signal Transmitting PortSFP/SFP+
Front Panel LEDs

Front Panel Ports
LEDs State Description
ALM
RUN
Always Red There is an alarm of the Power, Fan and NMU module.
Ther module type does not match.
There is no alarm of the module.
The module is normal.
The module does not work.
There is no LOS alarm of the port.
There is a LOS alarm of the port.
Quick Flash of Red Light
Always OFF
Slow Flash of Green Light
Always OFF
Always Green
Always Red
The transceiver does not match.Quick Flash of Red Light
The port is disabled.Always OFF
1~6
Ports DescriptionPort Type
Port 1~6 40/100Gbps Optical Transceiver Signal Transmitting PortQSFP+/QSFP28
Front Pannel LEDs

Front Panel Ports
Front Panel Ports
Front Panel Ports

Front Pannel LEDs
Panel Keys
Keys Description
AUTO/FORCE
PRI/SEC
Switching Working ModePress for switching auto mode or manual mode
Press for switching working channel of primary/second state Switching Working Channel
Function
State

Front Panel Ports
Ports Description
NMU Module
Fan
AC Power
Network Management Unit(NMU), the main control module of the chassis
Used for 1-slot/2-slot M6200 series business module
Support field-replacedable and hot-swappable
Blank Plate 1
Blank Plate 2~7
Used for 1+1 NMU module backup or M6200 series business module
AC power supply, 90VAC~264VAC, 45Hz~65Hz, supports 1+1 backup
Front Panel Ports
Ports Description
NMU Module
Fan
AC Power
Network Management Unit(NMU), the main control module of the chassis
Used for 1-slot/2-slot M6200 series business module
Support field-replacedable and hot-swappable
Blank Plate 1
Blank Plate 2~15
Only used for 1+1 NMU module backup
AC power supply, 110VAC~260VAC, 50Hz~60Hz, supports 1+1 backup

Front Panel Ports
Front Panel LEDs
LEDs Status Description
RUN
ALM
ACT
Always OFF The module is not normally enabled.
Quick Flash
Always OFF
Always ON
Always OFF
Always ON
The module works normally.
The module is the secondary module.
The module is the primary module.
There is no alarm.
There is an alarm on the power supply, the fan or the NMU Modulee.
Ports Port Type Description
MGMT 1~4
MGMT 5~6
CONSOLE RJ45 Debugging & Upgrading port
SFP Out of band OSC management
RJ45
Connect to the local network
management computer
Interface for NMS concatenation
equipment
1
2
Rate
10/100M
Auto-negotiate
100M
/

1. Secure the mounting brackets to the two sides of the M6200 series managed chassis with M4
screws.

1. Secure the grounding lug to the grounding point on the chassis front panel with the washers and a
screw.
2. Connect the other end of the cable to a proper earth ground, such as the rack in which M6200
series is mounted.
CAUTION: The earth connection must not be removed unless all supply connections have
been disconnected.

1. Connect one end of the standard RJ45 Ethernet cable to the MGMT1 or MGMT2 port on the front of
NMU module.
2. Connect the other end of the cable to a computer.
NOTE: 1. SFP management port is designed for long-haul management of more than 100m.
2. RJ45 management port is designed for short-haul management of less than 100m.
3. You can start your management by selecting one of the above six management ports.
Step 1: Connect your computer with the network cable to any Ethernet MGMT port of the NMU
module.
Step 2: Download the le "NMS software" online, and then install it.
NMS Server
Step 3: Double Click “NMS Server” icon on the desktop and the dialogue box of license validation will
pop up. Enter the license key to nish the validation. (To get the information about the license
key, please pay attention to the e-mail after the purchase or contact the FS sales manager for
help.)

Step 7: Click login, you are now ready to congure M series platform.
NOTE: Refer to the M SERIES NETWORK MANAGEMENT USER MANUAL online for further
information.

Online Resources
Download https://www.fs.com/products_support.html
Help Center https://www.fs.com/service/fs_support.html
Contact Us https://www.fs.com/contact_us.html
Product Warranty
Warranty: The products enjoy a 2-year limited warranty against defects in materials or
workmanship. For more details about the warranty, please check at
https://www.fs.com/policies/warranty.html
FS ensures our customers that for any damage or faulty items due to our workmanship, we will oer a
free return within 30 days from the day you receive your goods. This excludes any custom-made items
or tailored solutions.
2
Return: If you want to return the item(s), information on how to return can be found at
https://www.fs.com/policies/day_return_policy.html