FS S3700-24T4F User manual

S3700-24T4F RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
www.fs.com
I
Model: S3700-24T4F
Reset and Recovery System
Configuration Guide

S3700-24T4F RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
www.fs.com
I
Contents
1. Configuration Considerations...............................................................................................................................................................1
2. Network Topology.................................................................................................................................................................................. 1
3. Operation Steps......................................................................................................................................................................................1
3.1 Connection Equipment....................................................................................................................................................................1
3.2 Download Configuration Software..................................................................................................................................................1
3.3 Switch On and Use Login Software..................................................................................................................................................1
3.4 Restoration System...........................................................................................................................................................................2
3.5 Switch to Factory Reset.................................................................................................................................................................... 3

S3700-24T4F RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
www.fs.com
1
1. Configuration Considerations
Table 1 products and versions for example.
Series
Product
Support version
S3700
S3700-24T4F
2. Network Topology
3. Operation Steps
3.1 Connection Equipment
#According to the way of networking topo to connect PC and switch to network cable and Console. One end of the RJ-45 network cable is
connected to the PC NIC, and the other end is connected to the SW's network port. Connect one end of Console line USB to PC's USB
interface, and the other end of RJ-45 is connected to console interface of front panel of switch.
3.2 Download Configuration Software
#After the connection is completed, there we recommend the super terminal, putty or Secure CRT tool to configure the switch.
3.3 Switch On and Use Login Software
#Energizing the switch, then open the installed login software, select the serial port of login mode, port through the device manager to
determine. Baud rate :115200, Data bits: 8, Parity: None ,Stop bits: 1. (Reference below)

S3700-24T4F RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
www.fs.com 2
NOTE: COM Number can be viewed through device manager. (right click on my computer.>manage>device manager>port (COM and
LPT）If it displays an unrecognized USB device, please download and install the corresponding driver.
3.4 Restoration System
*Please use Ctrl + P to enter the monitor # interface when restarting the switch，then configure the switch IP address:
monitor#ip address 192. 168.1.1 255.255.255.0
*Set PC IP address

S3700-24T4F RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
www.fs.com
3
*Then prepare tftp
*Then start upgrading the system: run copy tftp flash.
Monitor#copy tftp flash //From ftp to flash
Source file name[ ]? FS-S1400-24T4F-2.2.0C.bin //Firmware file name
Remote-server ip address[ ]? 192.168.1.2 //TFTP Server IP address
Destination file name[FS-S1400-24T4F-2.2.0C.bin]? //Switch.bin
When prompted: TFTP: successfulfully sent ...
After the success # reboot just fine
3.5 Switch to Factory Reset
Switch#delete startup-config
this file will be erased, are you sure?(y/n)y
Switch#reboot
If the file name is not entered, the startup-config files will be deleted by default.

S3910 SERIES SWITCHES DATASHEET
www.fs.com 10