FujiFilm SonoSite Edge II User manual

1
Triple Transducer Connect (TTC)
Assembly Instructions
.
SonoSite Edge II system
with TTC installed.

2
Unpacking the box
Triple Transducer Connect (1)
Left-side mounting bracket (1)
Allen-head wrench (1)
Right-side mounting bracket (1)
Allen-head screw (4)

3
Preparing the stand
Attaching the TTC brackets to the stand head
STEP 1 STEP 2
Unlock the system latches. Disconnect the
transducer, mini-dock, and any other cables
from the ultrasound system, and then
remove the system from the stand.
To lock the stand, press down the lever on two
or more wheels.
STEP 3 STEP 4
Insert the screws into the brackets. Using the Allen wrench, attach the left-side
mounting bracket to the underside of the
stand head. Make sure the latch points
outward.
Rear

4
Inserting the TTC
STEP 5 STEP 6
Using the Allen wrench, attach the right-
side mounting bracket to the underside of
the stand head. Make sure the latch points
outward.
Rear
Tighten the bracket screws.
STEP 7 STEP 8
Insert TTC connector through the bottom
of the stand head.
Slide the TTC into the mounting brackets,
and then push to engage the latches on
both mounting brackets.

5
Connecting the TTC to the ultrasound system
Caution To avoid damaging the system, use only peripherals recommended by FUJIFILM
SonoSite with the ultrasound system.
STEP 9 STEP 10
Insert the TTC connector into the
ultrasound system.
Rotate the latch counterclockwise.
STEP 11 STEP 12
Flip the latch handle up, securing the
connector to the ultrasound system.
Lower the ultrasound system into the
stand head, and lock it in place using the
system latches. Reconnect the mini-dock
and any cables that were removed in
Step 2.