Furniture of America Bellagio CM3319M User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3319M
Phillips Screwdriver
Assembly Instructions
Tools Required for Assembly:
Rev.14-05-07
Page 1 of 4
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
(Not Included)

Page 2 of 4

Parts List
#1 x 1 pc
Mirror #A x 4 pcs
Screw
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Due to the size and/or weight of this product, it
is highly recommended that the assembly
should be done near the area of its intended
location. Make sure you have enough space
to move around during the assembly.
ALWAYS have at least two people to help with
transporting and assembling the product to
avoid any potential injury and/or damage.
MD
Page 3 of 4
#B x 1 pc
Wall Anchor

Page 4 of 4
Turn right (clockwise) to tighten
I. Wall Mount to Drywall: Select a location where you want the mirror to be mounted.
Mark on the wall the two locations where the wall anchors (#B) will be placed. Drill
a hole for each wall anchor (#B) slightly smaller then the size of the screw. Push
the wall anchor (#B) as far as it will go with your finger. Tap gently with a hammer
until the wall anchor (#B) is flush with the wall surface. Insert the screws (#A) into
the wall anchors (#B) and tighten those screws using a Phillips screwdriver until
secured but leaving enough room to hang the mirror. Note: Due to the weight of
the mirror, it is highly recommended to secure the mirror to the wood stud.
II. Wall Mount to Wood Stud (Highly Recommended): Locate the wood stud behind
the drywall. Repeat the process above using only the screws (#A). For securing
onto the wood stud, wall anchor is not needed.
ASSEMBLY IS COMPLETED