Furniture of America CM4033S User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM4033S
Allen Wrench (Not Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-07-15
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED

Thank you for your purchase!
We hope you will enjoy your new product for many years to come. Our commitment
to providing quality products does not simply end when a purchase is made. We
stand behind our products and will provide any support needed in order for you to
fully enjoy your purchase. Your satisfaction is the greatest recognition we could
have.
Because we value your trust in our company, we will do our best to meet your
service expectations. Should you have any assembly related questions, parts
replacement requests, comments or suggestions, please feel free to contact us any
time. To help expedite the service, please have the assembly instructions available,
along with your order receipt.
[email protected]
www.foagroup.com
1-626-363-9311
1-626-270-4451
Monday to Friday 8:30 a.m. to 5:30 p.m. (PST)
https://twitter.com/foagroup
http://www.pinterest.com/foagroup/
http://instagram.com/foagroup#
https://www.youtube.com/user/FurnitureOfAmerica
Page 2 of 5

Page 3 of 5

Parts List Hardware List
#1 x 1 pc
Table Top
#2 x 4 pcs
Leg
#3 x 1 pc
Glass Top
#A x 1 pc
Bolt 5/16”x2”
#B x 8 pcs
Flat Washer
Before you begin, please read Page 3
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Lock Washer
MD
#D x 8 pcs
Allen Wrench
Page 4 of 5
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.

Page 5 of 5
I. With the help of another person,
carefully place the table top (#1)
facing down on a protective
surface.
II. Align the 4 legs (#2) with the pre-
drilled holes on the bottom of the
table top (#1).
III. Prepare 8 bolt assemblies by
inserting FIRST the lock washer
(#C) onto the bolt (#A) and then
the flat washer (#B) onto the
SAME bolt (#A), in that order.
IV. Insert the bolt assemblies through
the pre-drilled holes of the table
top (#1) and secure those bolts
using the Allen wrench (#D) to
lock them with the legs (#2).
#B x 8 pcs
#C x 8 pcs
#D x 8 pcs
I. Carefully place the table in its upright position. Place the glass top
(#3) onto the center of the table top (#1).
II. Make sure the table is rested on a flat surface and does not feel
loose or wobbly. If it does, double check that the bolts are secured
and properly tightened.
Turn right (clockwise) to tighten
ASSEMBLY IS COMPLETED