Furniture of America Brocket CM-BK1035F User manual

Rev.15-04-02

I. Align the back rail (#3) and front rail (#4)
to the upper end rails (#1).
II. Align a spacer (#G) to each corner and
insert bolts (#J). Secure using the Allen
wrench (#H).
I. Align the down back rail (#9) and down
front rail (#10) to the down end rails (#12).
II. Align a spacer (#G) to each corner and
insert bolts (#J). Secure using the Allen
wrench (#H).
III. Insert bolts (#J) into the outer corner pre-
drilled holes as well and secure using the
Allen wrench (#H).

I. Insert 4 connect tubes (#7) into each
hole located at the top of the down
end rails (#12).
II. Insert a bolt (#A) into each and secure
using the Allen wrench (#H).
I. Insert the bottom of the upper end
rails (#1) into each hole located at
the top of the connect tubes (#7).
II. Insert a bolt (#A) into each and
secure using the Allen wrench (#H).

I. Align the guard rails (#2) in between the two upper end rails (#1).
II. Insert 2 bolts (#D) into each corner and secure using the Allen wrench (#H).
III. Insert 2 bolts (#E) into the center of the back/front rails to connect with the
guard rails and secure using the Allen wrench (#H).
I. Align the bed frames (#6) in the center
and the bed frames (#5) on the outer
ends of the beds.
II. Insert the bolts (#B) into each bed
frame and secure using the Allen
wrench (#H).
Align the stairs (#14) to the side of the bunk bed.
Insert the bolts (#D) and secure using the Allen
wrench (#H).

I. Align one bed middle connect (#11)
in between the upper end rails (#1)
and one in between the down end
rails (#12).
II. Insert bolts (#D) into each side and
secure using the Allen wrench (#H).
III. Insert the bolts (#C) from below as
shown and secure using the Allen
wrench (#H).
Align support leg (#13) under the bottom
bed and insert 2 bolts (#C). Secure using
the Allen wrench (#H).

To separate remove guard rails.
Switch so that each bed has a headboard and footboard.

Apply a support leg (#13) below each bed.
Apply covers (#I) to
each end.