Furniture of America California CM7481Q User manual

For more information contact our team: [email protected]
16-11-15

1) Prepare 8 bolts assembly by inserting lock
washer (#B), then flat washer (#C) onto bolts (#A).
2) Align cross bar support (#3) to the holes of the
legs (#2R/L) and then secure lightly (not too tight)
with bolts (#A).
3) Align legs (#2R/L) to the headboard (#1), then
secure with bolts (#A). Tighten bolts (#A) on cross
bar support (#3).
Hook the side rails (#7) to the latch on the headboard (#1) and footboard (#6).
Make sure it is firmly secured.

Attach 2 support legs (#5) to each slats (#4).
Adjust floor protector according to ground
level.
Align the slats (#4) to the side rails (#7). Secure with screws (#E). There are no pre-
drilled holes on the side rails (#7).

For more information contact our team: [email protected]
16-11-15

1) Prepare 8 bolts assembly by inserting lock
washer (#B), then flat washer (#C) onto bolts (#A).
2) Align cross bar support (#3) to the holes of the
legs (#2R/L) and then secure lightly (not too tight)
with bolts (#A).
3) Align legs (#2R/L) to the headboard (#1), then
secure with bolts (#A). Tighten bolts (#A) on cross
bar support (#3).
Hook the side rails (#7) to the latch on the headboard (#1) and footboard (#6).
Make sure it is firmly secured.

Attach 2 support legs (#5) to each slats (#4).
Adjust floor protector according to ground
level.
Align the slats (#4) to the side rails (#7). Secure with screws (#E). There are no pre-
drilled holes on the side rails (#7).