Furniture of America Verona CM4484E User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-06-26
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
CM4484E

Thank you for your purchase!
We hope you will enjoy your new product for many years to come. Our commitment
to providing quality products does not simply end when a purchase is made. We
stand behind our products and will provide any support needed in order for you to
fully enjoy your purchase. Your satisfaction is the greatest recognition we could
have.
Because we value your trust in our company, we will do our best to meet your
service expectations. Should you have any assembly related questions, parts
replacement requests, comments or suggestions, please feel free to contact us any
time. To help expedite the service, please have the assembly instructions available,
along with your order receipt.
[email protected]
www.foagroup.com
1-626-363-9311
1-626-270-4451
Monday to Friday 8:30 a.m. to 5:30 p.m. (PST)
https://twitter.com/foagroup
http://www.pinterest.com/foagroup/
http://instagram.com/foagroup#
https://www.youtube.com/user/FurnitureOfAmerica
Page 2 of 5

Page 3 of 5

Parts List Hardware List
#1 x 1 pc
Table Top
#2 x 4 pcs
Leg
#3 x 1 pc
Base
#A x 8 pcs
Flat Washer
#B x 8 pcs
Lock Washer
Before you begin, please read Page 3
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Bolt 5/16”x2”
MD
#D x 1 pc
Allen Wrench
Page 4 of 5

Page 5 of 5
I. Align the legs (#2) with the pre-
drilled holes on the corners of
the base (#3).
II. Prepare 4 bolt assemblies by
inserting FIRST the lock
washer (#B) onto the bolt (#C)
and then the flat washer (#A)
onto the SAME bolt (#C), in
that order.
III. Insert the bolt assemblies
through the pre-drilled holes of
the corners of the base (#3)
and secure those bolts using
the Allen wrench (#D) to lock
them with the legs (#2).
#A x 4 pcs
#B x 4 pcs
#C x 4 pcs
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
I. Carefully place the table top (#1)
facing down on a protective
surface.
II. Align the legs (#2) assembled onto
the base (#3) with the pre-drilled
holes on the bottom corners of the
table top (#1).
III. Prepare 4 bolt assemblies by
inserting FIRST the lock washer
(#B) onto the bolt (#C) and then the
flat washer (#A) onto the SAME bolt
(#C), in that order.
IV. Insert the bolt assemblies through
the pre-drilled holes on the bottom
corners of the table top (#1) and
secure those bolts using the Allen
wrench (#D) to lock them with the
legs (#2).
V. Carefully turn the completed table
upright. Make sure the table is
rested on a flat surface and does
not feel loose or wobbly. If it does,
double check that the bolts/screws
are secured and properly tightened.
#A x 4 pcs
#B x 4 pcs
#C x 4 pcs
ASSEMBLY IS COMPLETED