Furniture of America CM-AC336-3A User manual

1. Insert the threaded ends of the cam bolts (#A) into the holes
along the back and front panels (#4,5). Turn right to tighten.
2. Insert the cam locks (#B) into the large holes
along the side of the middle panels (#6), make
sure to have the openings face the holes along
the sides. Then insert the other ends of the
cam bolts (#A) into those cam locks. Secure
the cam locks (#B) using a screwdriver.
1. Insert the threaded ends of the cam bolts (#A) into the holes
along the left and right side panels (#2,3). Turn right to tighten.
2. Insert the cam locks (#B) into the large holes along the side of
back panel (#4), make sure to have the openings face the holes
along the sides. Then insert the other ends of the cam bolts (#A)
into those cam locks. Secure the cam locks (#B) using a screwdriver.
3. Align and insert 2 bolts (#C) into each
end. Secure using the Allen wrench (#F).
4. Prepare 8 bolt assemblies by
first inserting a lock washer (#D)
onto the bolt (#C) then a flat
washer (#E) onto that same
bolt (#C). Insert 2 into each end
of the bottom panel (#7). Secure.

1. Insert the threaded ends of the
cam bolts (#A) into the holes.
Turn right to tighten.
2. Insert the cam locks (#B) into the
large holes along the bottom side
of the top panel (#1), make sure
to have the openings face the holes
along the sides. Then insert the
other ends of the cam bolts (#A) in
to the holes along the side. Secure
cam locks (#B) using a screwdriver.
1. Insert the threaded ends of
the cam bolts (#J) into the
holes along the drawer fronts
(#8), then insert a cam lock
(#K) into each hole along the
left and right drawer side
panels (#10,11). Make sure
to align the opening to the
holes, then insert the other
end of the cam bolt (#J) in
to those cam locks (#K).
Secure cam lock using a
Phillips screwdriver.
2. Slide the drawer bottom panel (#13) along the
ridges of the side panels. Align the knobs (#H)
along the drawer fronts, then insert 2 bolts (#I)
into each and secure using a screwdriver.
3. Align the drawer back panel (#12)
to the holes along the side panels,
then insert 2 screws (#G) into each
side and secure using a screwdriver.

1. Drill a hole along the wall
slightly smaller than the
plug, then insert the plug
until fully secured.
2. Align a bracket to the plug,
then insert a long screw
and secure. After that align
the other bracket to the
back of the assembly and
insert a small screw. Secure
using a screwdriver.
3. Secure the strap accordingly.
ASSEMBLY IS COMPLETED
x2
Insert the drawers.