Furniture of America Coimbra Eastern CM7623Q User manual

1. Insert 2 dowels (#F) into each end of the leg support (#3), and the
other ends of the dowels into the right and left H/board legs (#2).
2. Prepare 2 bolt assemblies by applying a lock washer (#C) onto the bolt (#B)
then a flat washer (#D) onto that same bolt (#B). Insert a bolt assembly into
each end of the leg support (#3) and secure using the Allen wrench (#E).

1. Carefully place the headboard (#1) onto the top of the H/board legs (#2).
2. Prepare 6 bolt assemblies by applying a lock washer (#C) onto the bolt (#A)
then a flat washer (#D) onto that same bolt (#A). Insert 3 bolt assemblies into
each end of the headboard (#1) and secure using the Allen wrench (#E).
1. Insert 2 threaded studs (#G)
into the holes along the sides
of the headboard (#1) and
footboard (#4). Turn right.
.
2. Apply the each
end of the side
rails (#5) onto
those threaded
studs (#G).
3. Apply a hex nut (#H)
then a beveled
washer (#I) onto the
threaded studs (#G).
Secure the washer
using the wrench (#J).

Insert the threaded ends of the slat supports (#8) into
the holes along the slat center (#7). Turn right to tighten.
1. Apply the slats (#6) onto
the side rails (#5).
2. Turn the slat support legs
(#8) along the center to
the right. This will
connect the slat center
(#7) to the slats (#6).
3. Insert a screw (#K) into the
ends of the slats (#6). Secure
using the Phillips screwdriver.

1. Insert 2 dowels (#F) into each end of the leg support (#3), and the
other ends of the dowels into the right and left H/board legs (#2).
2. Prepare 2 bolt assemblies by applying a lock washer (#C) onto the bolt (#B)
then a flat washer (#D) onto that same bolt (#B). Insert a bolt assembly into
each end of the leg support (#3) and secure using the Allen wrench (#E).