Furniture of America CM-BK923 User manual

1. Align the lower front
side rail (#5) and lower
rear side rail (#6).
2. Insert 2 round nuts (#A) into the
large holes at each end of the side
rails, then insert 2 bolts (#A) into
the lower left/right end G/rails (#1,2).
Secure using the Allen wrench (#K).
1. Insert a metal dowel (#I)
into the holes along the
top of the lower left and
right end G/Rails (#1,2).
2. Place the upper left and
right end G/Rails (#3,4)
onto those metal dowels.

1. Align the upper front side rail (#7)
and upper rear side rail (#8).
2. Insert 2 round nuts (#A) into the
large holes at each end of the side
rails, then insert 2 bolts (#A) into
the upper left/right end G/rails (#3,4).
Secure using the Allen wrench (#K).
3. Insert 2 wood
dowels (#J) into
each end of the
rear guardrails
(#9) and into
one end of the
front guardrails
(#10). Then
insert those
ends into the
G/rails (#3,4).
4. Insert a screw (#E)
into the upper left/right
end G/rails (#3,4) to
connect with the
guardrails. Secure using
the Allen wrench (#K).
1. Insert 2 wood dowels
(#J) into each end of the
front guardrails (#10).
2. Place the end guardrail support
(#12) and insert the other ends
of the wood dowels (#J), then
insert 2 screws (#F) into the
support (#12) to connect with
the guardrails (#10). Secure
using the Allen wrench (#K).
3. Insert 2 bolts (#B) to the
holes along the bottom of
the support (#12) and secure
using the Allen wrench (#K).
4. Align the guardrail
supports (#11) to the
center of the rails and
insert 3 bolts (#D) into
each from within the
rails. Secure using the
Allen wrench (#K).

1. Insert the ladder rungs (#15)
into the slots along the left/
right ladder rails (#13,14).
2. Insert a screw (#G)
into the holes along
the ladder rungs (#15)
and secure using the
Allen wrench (#K).
1. Align the ends of the left/right
ladder rails (#13,14) to the rails.
2. Insert 2 bolts (#C) into each
end from within and secure
using the Allen wrench (#K).

Carefully place the twin
slat kit (#16) onto the top
bed and the full slat kit
(#17) to the bottom bed.
Insert a screw (#H) into
each end and secure using
a Phillips screwdriver.
Make sure the beds do not feel wobbly or loose and all parts are firmly secured.