Furniture of America CM-BK937 User manual

Rev: 18-12-05
Page 1 of 12
For more information contact our team: [email protected]

Page 2 of 12

Page 3 of 12

Page 4 of 12

Page 5 of 12
Align side support frames (#1) to the bed slat (#2), then
secure by using bolts (#C) with washers (#A).
DO NOT FULLY TIGTHEN ALL BOLTS
UNTIL ASSEMBLY IS COMPLETED.

Page 6 of 12
Align bed slat (#2) to the side support frames (#1), then
secure by using bolts (#C) with washers (#A)
Align bed slat (#2) to the side support
frames (#1), then secure by using bolts
(#C) with washers (#A)

Page 7 of 12
Align long ladder (#3) to the holes of the
bunk bed, then secure by using bolts
(#D) with washers (#E), to hex nut (#G).
Align short ladder (#4) to the holes of the
bunk bed, then secure by using bolts (#D)
with washers (#E), to hex nut (#G).

#D x 3pcs
Page 8 of 12
Align front middle guardrail (#5) to the holes of the bunk bed, then
secure by using bolts (#D) with washers (#E), to hex nut (#G).
Align front top guardrail (#6) to the holes of the bunk bed, then
secure by using bolts (#B) with washers (#E), to hex nut (#G).

Page 9 of 12
Align back guardrail (#7) to the holes of the bunk bed, then
secure by using bolts (#B) with washers (#E), to hex nut (#G).
Align back guardrail (#7) to the holes of the
bunk bed, then secure by using bolts (#B) with
washers (#E), to hex nut (#G).

Page 10 of 12
Use plugs (#J,K) to cover holes.
Wall
Wall
SCREWDRIVER
1) Place bunk bed by the wall to measure out the general area of where
the wall anchor should be placed.
2) Secure metal plate (#N) to the wall anchor (#O) by using screws (#M).