Furniture of America CM1927WH User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-12-10
Page 1 of 9
DIFFICULT
ASSEMBLY RATING
CM1927
2 PERSONS RECOMMENDED
Phillips Screwdriver
(Not Included)

Page 2 of 9

Parts List
Page 3 of 9
#4 x 1 pc
Front Trundle Panel
#1 x 1 pc
Left Headboard
#3 x 1 pc
Guardrail
#7 x 1 pc
Top Trundle Support
#9 x 3 pcs
Trundle Guide
#6 x 2 pcs
End Trundle Panel
#10 x 3 pcs
Drawer Guide
#2 x 1 pc
Right Headboard
#5 x 1 pc
Rail
#8 x 1 pc
Bottom Trun. Support
#11 x 3 pcs
Front Drawer Panel
#13 x 3 pcs
Left Drawer Panel #14 x 3 pcs
Right Drawer Panel
#12 x 3 pcs
Rear Drawer Panel
#15 x 3 pcs
Bottom Drawer Panel #16 x 1 set
Slat Kit (13 pcs)
Before you begin, please read Page 2
for “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
MD

#D x 3 sets
Handle Assembly
Hardware List
#A x 4 sets
Bolt w/Nut
#C x 69 pcs
Screw
Page 4 of 9
#B x 26 pcs
Bolt M6.3x30mm
#E x 1 pc
Allen Wrench
Due to the size and/or weight of this product, it
is highly recommended that the assembly
should be done near the area of its intended
location. Make sure you have enough space to
move around during the assembly. ALWAYS
have at least two people to help with
transporting and assembling the product to
avoid any potential injury and/or damage.

Page 5 of 9
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
#A x 4 sets
#B x 8 pcs

Page 6 of 9
Turn right (clockwise) to tighten
#B x 4 pcs
#B x 6 pcs
Turn right (clockwise) to tighten

Page 7 of 9
Turn right (clockwise) to tighten
#C x 24 pcs
#C x 6 pcs

Page 8 of 9
Turn right (clockwise) to tighten
#D x 3 sets
#B x 8 pcs

Page 9 of 9
Turn right (clockwise) to tighten
Safety is ALWAYS the main priority. For extra safety
measure and before using the bed, please take the time
to inspect the assembly again and make sure that ALL
bolts and screws are FULLY tightened.
ASSEMBLY IS COMPLETED
#C x 39 pcs