Furniture of America Milbank CM4110C User manual

Rev: 17-01-17

I. Screw 4 cam bolts (#A) into the left side panel (#3) and the right side panel (#4) using a Phillips
screwdriver.
II. Insert the other end of the cam bolts (#A) into the bottom panel (#5).
III. Insert cam locks (#B) into the pre-drilled holes on the bottom panel (#5) and lock using a Phillips
screwdriver.
I. Screw 7 cam bolts (#A) into the back panel (#1) using a Phillips screwdriver.
II. Insert the other end of the cam bolts (#A) into the left side panel (#3), the right side panel (#4)
and the bottom panel (#5).
III. Insert 7 cam locks (#B) into the pre-drilled holes and lock using a Phillips screwdriver.
IV. Apply adhesive pads.
7pcs
7pcs
7pcs

I. Screw 7 cam bolts (#A) into the front panel (#2) using a Phillips screwdriver.
II. Insert the other end of the cam bolts (#A) into the left side panel (#3), the right side panel (#4)
and the bottom panel (#5).
III. Insert 7 cam locks (#B) into the pre-drilled holes and lock using a Phillips screwdriver.
IV. Apply adhesive pads.
7pcs
7pcs
7pcs
I. Insert the top stretchers (#8) and bottom stretcher (#9) into the designated
slots located on the metal side frames (#7).
II. Insert bolt (#N) and secure using the Allen wrench (#M).

Align the hinges (#F) to the pre-drilled holes located on the back panel (#1) and
top panel (#6) insert screw (#G). Secure using a Phillips screwdriver.
I. Align the bottom assembly to the bottom panel (#5).
II. Insert flat washer (#L) onto the bolt (#K) then secure using the Allen
wrench (#M).

I. Align the left support (#C) and right support (#D) to the corners and insert screw (#E).
Secure using a Phillips screwdriver.
II. Align handle (#H) to the pre-drilled holes along the sides and insert the bolts (#I).
Secure using a Phillips screwdriver.
III. Apply the adhesive pads (#J) on the front corners.
ASSEMBLY IS COMPLETED