Furniture of America CM7057T User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7057T
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-04-22
Page 1 of 5
DIFFICULT
ASSEMBLY RATING

Page 2 of 5

Parts List Hardware List
#1 x 1 pc
Headboard
#2 x 2 pcs
Side Rail
#3 x 1 pc
Footboard
#A x 8 pcs
Bolt M8x1”
#B x 8 pcs
Bolt M8x3”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 16 pcs
Flat Washer
MD
#D x 16 pcs
Lock Washer
#4 x 4 pcs
Foot
Page 3 of 5
#E x 26 pcs
End Cap
#F x 1 pc
Allen Wrench
#5 x 13 pcs
Slat
Due to the size and/or weight of this product, it is highly
recommended that the assembly should be done near the
area of its intended location. Make sure you have enough
space to move around during the assembly. ALWAYS have
at least two people to help with transporting and assembling
the product to avoid any potential injury and/or damage.

Turn right (clockwise) to tighten
Page 4 of 5
Enlarged
Enlarged
#B x 8 pcs
#C x 8 pcs
#D x 8 pcs
I. Align the feet (#4) onto the pre-drilled holes on the bottom corners of the
headboard (#1).
II. Prepare 4 bolt assemblies by inserting FIRST the lock washer (#D) onto the
bolt (#B) and then the flat washer (#C) onto the SAME bolt (#B), in that
order.
III. Insert the bolt assemblies through the holes of the feet (#4) and secure
those bolts using the Allen wrench (#F) to lock them in with the headboard
(#1).
IV. Repeat the process above to assemble the feet (#4) onto the footboard
(#3).
Turn right (clockwise) to tighten
I. Prepare 4 bolt assemblies by inserting
FIRST the lock washer (#D) onto the bolt
(#A) and then the flat washer (#C) onto
the SAME bolt (#A), in that order.
II. Insert two bolt assemblies through each
side of the pre-drilled holes of the
headboard (#1) using theAllen wrench
(#F) but expose about ½” of the bolts’
threads.
III. Mount the brackets of the side rails (#2)
onto the bolts (#A) on each side of the
headboard (#1). Make sure all the
washers are in the FRONT of the
brackets. Use the Allen wrench (#F) to
tighten the bolts with the two parts
together.
IV. Repeat the process I through III above to
assemble the other ends of the side rails
(#2) onto the footboard (#3).
#A x 8 pcs
#C x 8 pcs
#D x 8 pcs

Page 5 of 5
Enlarged
#E x 26 pcs
.
I. Prepare a complete bed slat by connecting two end caps (#E)
onto the ends of the bed slat (#5).
II. Align the end caps (#E) with the pre-drilled holes on each side
of the side rails (#2) and snap both ends to lock in place.
III. Repeat the above process for the remaining 12 bed slats.
ASSEMBLY IS COMPLETED
Note: The correct position of the bed
slats should be arcing UPWARD
when placing on the rails.