Furniture of America CM7059 User manual

CM7059
Assembly Instructions
EASY DIFFICULT
Page 1 of 7
ASSEMBLY RATING
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Rev: 2017-05-08
2 PERSONS RECOMMENDED
Tools Required For Assembly:
Allen Wrench (Included)
Phillips Screwdriver (Not Included)
For more information contact our team: [email protected]

Parts List
Hardware List
Before you begin, please read Page 2
of "Assembly and Care Advice".
And remember, do not tighten until
each step is completed or instructed.
Page 3 of 7
#1 x 1pc
#2 x 1pc
#4 x 3pcs
#3 x 2pcs
#5 x 4pcs
#6 x 1pc
Footboard Panel
Bed Rail
Support Rail
Center Rail
Leg Support
#7 x 1Set
Slats (13pcs)
#8 x 6pcs
Drawer #9 x 2pcs Dust Board
#C x 6pcs
U Shaped Lock
#A x 22pcs
Headboard Panel Screw (Ø4 x 1-3/8")
#B x 24pcs
Screw (Ø4 x 5/8")
#D x 12pcs
Screw (Ø4 x 3/4")

Hook each end of the bed rails (#3) onto
the slots along the headboard panel (#1).
Place the support rails (#4) onto the slots along
the bed rails (#3), then insert a screw (#A) into
each hole. Secure using a screwdriver.

Page 5 of 7
#6
#5
leveler
#4
#A
#8
#3
#3
#A x 2pcs
#C x 6pcs
#D x 12pcs
#D
#D
#C
#C
Insert the threaded end of the support legs into the holes
along the center rail (#6), then turn right to tighten.
Adjust according to
the ground level.

Place the center rail (#6)
onto the center slots along
the headboard and foot-
board. Insert a screw (#A)
into each end and secure
using a screwdriver.
Place the slats (#7)
onto the rails, then
insert a screw (#A)
into each hole. Secure
using a screwdriver.

Place the dust boards
(#9) onto the bottom
end of the slats, then
insert a screw (#B) into
each hole. Secure
using a screwdriver.
#9