Furniture of America CM7131 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7131
Assembly Instructions
Tools Required for Assembly:
Rev.14-12-22
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
Allen Wrench
2 PERSONS RECOMMENDED
(Included)

Page 2 of 5

Parts List Hardware List
#1 x 1 pc
Headboard
#2 x 2 pcs
Headboard Leg
#3 x 1 pc
Footboard
#A x 10 pcs
F/H Bolt 1/4”x5/8”
#B x 8 pcs
Bolt 1/4”x7/8”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Plastic Washer
MD
#D x 8 pcs
Flat Washer
#4 x 1 pc
H/B Leg Rail
Page 3 of 5
#E x 8 pcs
Lock Washer
#F x 1 pc
Allen Wrench
#G x 2 pcs
Bracket
Due to the size and/or weight of this product, it is highly recommended that the
assembly should be done near the area of its intended location. Make sure you have
enough space to move around during the assembly. ALWAYS have at least two people
to help with transporting and assembling the product to avoid any potential injury and/or
damage.

Page 4 of 5
I. Align the headboard leg rail (#4) with the pre-drilled holes on
the 2 headboard legs (#2).
II. Insert 2 flat-head bolts (#A) through the headboard leg rail (#4)
using the Allen wrench (#F) to lock them with the headboard
legs (#2).
#A x 8 pcs
#G x 2 pcs
Turn right (clockwise) to tighten
I. Align the 2 headboard legs (#2) with the pre-drilled holes on the
headboard (#1). Then align the 2 brackets (#G) with the
headboard (#1) and the headboard legs (#2).
II. Insert 8 flat-head bolts (#A) through the brackets (#G) using the
Allen wrench (#F) to lock them with the headboard (#1) and the
legs (#2).
#A x 2 pcs
#G
Turn right (clockwise) to tighten

Turn right (clockwise) to tighten
Page 5 of 5
#B x 8 pcs
#C x 8 pcs
#D x 8 pcs
#E x 8 pcs
This is an optional step to assemble the headboard/footboard onto the bed frame (sold
separately).
ASSEMBLING THE BED FRAME TO THE HEADBOARD/FOOTBOARD
I. Align the holes of the bed frame with the holes on the headboard legs (#2) of the
assembled headboard.
II. Prepare 4 bolt assemblies by inserting FIRST the lock washer (#E) onto the bolt
(#B) and then the flat washer (#D) onto the SAME bolt (#B), in that order.
III. Insert the bolt assemblies through the bed frame, then insert 4 plastic washers
(#C) onto the same bolts (#B) and secure those bolts using theAllen wrench (#F)
to lock them in with the headboard legs (#2).
IV. Repeat the process above to assemble the other ends of the bed frame onto the
footboard (#3).
ASSEMBLY IS COMPLETED
Turn right (clockwise) to tighten
#3