Furniture of America CM7088V-1 User manual

Assembly
Instructions
EASY DIFFICULT
2 PERSONS RECOMMENDED
Tools Required For Assembly:
Allen Wrench
(Included)
ASSEMBLY RATING
Page 1 of 4
CM7088V-1&2
Rev: 16-12-08
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
For more information contact our team: [email protected]

FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY.
PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE.
BASIC ASSEMBLY TECHNIQUES
FAILURE TO FOLLOW THE GUIDELINES ABOVE MAY
RESULT IN INJURY AND/OR PROPERTY DAMAGE.
FURNITURE OF AMERICA.ALL RIGHTS RESERVED.
When lock or spring washer is used in
an assembly, please make sure the
lock or spring washer is placed
between the larger flat washer and the
head of the screw or bolt.
Position each part correctly and insert
screws or bolts into their respective
holes by hand tighten or using the
proper hand tool. Only tighten when
step is completed or when instructed
to do so.
Use cardboard or carpet area when
assembling furniture to prevent
scratches

Make sure the furniture
rests on a flat and level surface with
each leg evenly touching the floor.
IT IS THE USER'S RESPONSIBILITY TO MAINTAIN THE FURNITURE.THE HARDWARE MAY
LOOSEN OVER TIME AND MAY CAUSE THE FURNITURE TO BE WOBBLY AND UNABLE TO
SUPPORT ITS INTENDED WEIGHT CAPACITY. THIS MAY LEAD TO COLLAPSE AND MAY
CAUSE SERIOUS INJURY.
Some furniture comes with height
adjusetment knobs underneath each
leg. To lower or to raise each leg, you
need to turn clockwise or
counterclockwise, respectively.
Make sure all parts are properly
aligned, then use the appropriate
hand tool to completely tighten the
bolts or screws. Do not use power
tools and do not overtighten.
Save the instructions and store the Allen
wrench or any supplied tool for later
maintenance. After two weeks, check
and tighten any loose hardware and
repeat again every six months thereafter.
Page 2 of 4

Page 3 of 4
Before you begin, please read Page 2
of "Assembly and Care Advice".
And remember, do not tighten until
each step is completed or instructed.
#A x 8pcs
Bolt Ø1/4" x 1-3/8"
Parts List Hardware List
#1 x 1pc
Vanity
#2 x 1pc
Mirror
#3 x 2pcs
Mirror Support
#B x 8pcs
Look washer Ø1/4"
#D x 1pc
Allen wrench M4
#C x 8pcs
Flat washer Ø1/4"
40mm
250mm 170mm 350mm 35mm
840mm
10 x 30mm H
20mm
620mm

#A x 8pcs
#B x 8pcs
#C x 8pcs
Page 4 of 4
ASSEMBLY
IS COMPLETED
#C
#B
#A
#D
#1
#2
#3
#3
Prepare 8 bolts assembly by inserting lock washer (#B), then flat washer (#C) onto bolts (#A).
Align mirror support (#3) to the holes of the vanity (#1) and mirror (#2). Secure with bolts (#A).