Furniture of America CM7941T User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7941T
Phillips Screwdriver
(not Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-06-18
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
Allen Wrench (Included)

Page 2 of 5

Parts List
#1 x 1 pc
Headboard
#2 x 1 pc
Left H/Board Leg
#3 x 1 pc
Right H/Board Leg
#D x 1 pc
Allen Wrench
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.
MD
#C x 6 pcs
Lock Washer
#4 x 1 pc
Footboard
Page 3 of 5
#E x 8 pcs
Screw
Hardware List
#5 x 2 pcs
Side Rail
#6 x 4 pcs
Slat
#A x 6 pcs
Bolt 5/16”x1-3/8”
#B x 6 pcs
Flat Washer

Page 4 of 5
I. Insert the hooks of the two
side rails (#5) into the slotted
bars of the headboard (#1).
Make sure the parts are
secured properly.
II. Insert the hooks on the other
ends of the two side rails
(#5) into the slotted bars of
the footboard (#4). Make
sure the parts are secured
properly.
I. Align the left HB leg (#2) with the
pre-drilled holes of the
headboard (#1).
II. Prepare 3 bolt assemblies by
inserting FIRST the lock washer
(#C) onto the bolt (#A) and then
the flat washer (#B) onto the
SAME bolt (#A), in that order.
III. Insert the bolt assemblies
through the left HB leg (#2) using
the Allen wrench (#D) to lock
them with the headboard (#1).
IV. Repeat the process above to
assemble the right HB leg (#3)
onto the headboard (#1).
Note: Right and
left are determined
by facing the
FRONT of the bed
in its upright
position.
Turn right (clockwise) to tighten
#A x 6 pcs
#B x 6 pcs
#C x 6 pcs Backside

Turn right (clockwise) to tighten
Page 5 of 5
#E x 8 pcs
ASSEMBLY IS COMPLETED
1. Align the 4 slats (#6) with the pre-drilled holes of the side rails
(#5).
2. Secure 2 screws (#E) onto the ends of the slat (#6) using a
Phillips screwdriver to tighten them with the side rails (#5).
3. Repeat the process to assemble the remaining 3 slats (#6) onto
the side rails (#5).