Furniture of America CM7941TR User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7941TR
Phillips Screwdriver
(not Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-07-03
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
Allen Wrench (Included)
CM7941TR TRUNDLE IS COMPATIBLE WITH CM7941T
OR CM7941F BED SET (SOLD SEPARATELY).

Page 2 of 5

Parts List
#1 x 1 pc
Front Panel
#2 x 2 pcs
Side Panel
#3 x 1 pc
Rear Panel
#D x 1 pc
Allen Wrench
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.
MD
#C x 8 pcs
Lock Washer
#4 x 6 pcs
Slat
Page 3 of 5
#E x 12 pcs
Screw
Hardware List
#5 x 1 pc
Center Panel
#6 x 1 pc
Bottom Panel
#A x 8 pcs
Bolt 5/16”x1-3/8”
#B x 8 pcs
Flat Washer

Page 4 of 5
I. Align the slat (#4) with the
pre-drilled holes on the back
of the front panel (#1)AND
the rear panel (#3).
II. Secure 2 screws (#E) into the
ends of the slat (#4) using a
Phillips screwdriver to tighten
them with the front panel (#1)
AND the rear panel (#3).
III. Repeat the process to
assemble the remaining 5
slats (#4) onto the front panel
(#1)AND the rear panel (#3).
I. Align the two side panels (#2)
with the pre-drilled holes on the
back of the front panel (#1).
II. Prepare 4 bolt assemblies by
inserting FIRST the lock washer
(#C) onto the bolt (#A) and then
the flat washer (#B) onto the
SAME bolt (#A), in that order.
III. Insert the bolt assemblies
through the pre-drilled holes of
the side panels (#2) using the
Allen wrench (#D) to lock them
with the front panel (#1).
IV. Repeat the process above to
assemble the other ends of the
two side panels (#2) onto the
rear panel (#3).
Turn right (clockwise) to tighten
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs
#E x 12 pcs Turn right (clockwise) to tighten

Page 5 of 5
Place the bottom panel (#6) over the assembled slats (#4).
Insert the center panel (#5) between the space of the
front panel (#1)AND the rear panel (#3).
ASSEMBLY IS COMPLETED