Furniture of America CM7946F 1 User manual

1. Place the left/right side rails (#1,2) onto a protected surface,
then align the headboard support (#7,8) as displayed
and insert a bolt (#C). Secure using the Allen wrench.
2. Align the rail support legs (#14) to
the end of the side rails (#1,2) with
the headboard supports (#7,8).
Then insert a bolt (#A) and a bolt
(#D). Secure using the Allen wrench.
3. Align the rail support legs (#14)
to the back ends of the side rail
(#1,2). Insert 2 bolts (#D) into each.
Secure using the Allen wrench (#F).
1. Align a rail support leg (#14) to
the hole along the center of the
headboard connect (#3). Insert
2 bolts (#D) into the leg. Secure
using the Allen wrench (#F).
2. Align each end of the the headboard connect (#3) to the holes
along the ends of the left/right side rails (#1,2). Insert 2 bolts
(#D) into each end and secure using the Allen wrench (#F).
3. Align each end of the the
footboard connect (#4) to the
holes along the ends of the left
/right side rails (#1,2). Insert 2
bolts (#D) into each end. Secure
using the Allen wrench (#F).

2. Align the bracket along the
headboard up connect (#9)
to the headboard up tube
frame (#10). Insert a bolt
(#D) and secure using the
Allen wrench (#F).
3. Place the slats
(#5) onto every
other slot along
the side rails.
4. Apply a flat washer
(#1) onto the bolt
(#D), then place the
slats (#16). Insert
bolts from below and
secure using the
Allen wrench.
#C x 2pcs
#D x 11pcs
#I x 6pcs
1. Align the headboard up tube frame (#10) to the
top of the headboard supports (#7,8) then insert
2 bolts (#D) into each end. Align the headboard
up connect (#9) and insert a bolt (#C) into each
end. Secure using the Allen wrench (#F).
1. Align the headboard frame (#11)
to the holes as displayed, then
insert a bolt (#E) into each top end.
Secure using the Allen wrench (#F).
2. Insert a bolt (#A) into each
bottom end. Secure using
the Allen wrench (#F).

2. Place the headboard panel (#12), then insert a bolt (#C) into
each hole from the back. Secure using the Allen wrench (#F).
1. Prepare 6 screws by inserting a flat washer (#H) onto
the screws (#G). Place the shelf (#13) on top, then insert
the screw assemblies. Secure using a screwdriver.
Align the footboard (#6) to
the front, then insert 2 bolts
(#D) into each end. Secure
using the Allen wrench (#F).

1. Align the wheels (#15) to the holes along the
sides of the side rails. Insert 2 bolts (#B) into
each. Secure using the Allen wrench (#F).
2. Align the slat support legs (#17) to the holes
along the center of the slats. From above
insert a bolt (#B). Secure using the Allen wrench.