Furniture of America CM-AC6260 User manual

Rev.15-12-16

Handle

2. Insert threaded ends of levelers (#B) into the pre-drilled
holes located on the bottom of the front door (#7).
3. Insert threaded ends of levelers (#B)
into the pre-drilled holes located on
the bottom of the rear panel (#6).
Adjust according to ground level.
2. Align the left side
panel (#3), the middle
panel (#4), and right
side panel (#5) to the
pre-drilled holes shown
in the image. Insert
bolts (#A) into each
panel and secure using
a Phillips screwdriver.
Note: Left and right
are determined
by facing the front.
1. Carefully place the rear panel
(#6) onto a protected surface.
1. Carefully place the front door
(#7) onto a protected surface.

1. Align the front door (#7) to the pre-
drilled holes along the sides of the
right, left, and middle panel.
2. Insert 4 bolts (#A) into each panel and
secure using the Phillips screwdriver.
2. Insert a total of 4 bolts (#A) from beneath into
the pre-drilled holes on each side of the top
panel and secure using the Phillips screwdriver.
1. Place top panel (#1) on top. 2. Insert 2 bolts (#C) into top holes on the rear panel.
Insert a bracket (#H) onto one of those bolts and
secure both with the Allen wrench (#F).

2. Insert a total of 4 bolts (#A) from within into
the pre-drilled holes on each side of the base
and secure using the Phillips screwdriver.
1. Align the base (#2)
to the bottom.
3. Insert 2 bolts (#C) into the pre-
drilled holes along the outside
of the base to connect with
the side panels. Secure using
a Phillips screwdriver.
1. Place the clothes rail (#9) into the slots located inside.
2. Prepare 2 bolts by
inserting a small flat
washer (#N) onto
the bolts (#D), then
align the handle (#L)
to the doors. Insert
a bolt assembly into
each hole and secure
using a screwdriver.
3. Apply the shelves (#10,8).

2sets
THE PARTS ARE FOR

A
SSEMBLY IS COMPLETED
1. Determine exactly where you want to
drill a hole and mark the spot(s). Be
sure that you hold the drill perpendicular
to the wall so that the anchor will sit
parallel. You should drill a hole that is
approximately the same size as the
anchor bolt (#I) itself. Insert anchor.
2. Insert one end of the bracket (#H) onto the screw (#K) then
insert screw into the anchor. Secure using a Phillips screwdriver.
Use girding (#J) to attach the
bracket on the wall and the
bracket on the rear panel.