Furniture of America Lyss CM-AC6214 User manual

For more information contact our team: [email protected]
17-04-27

Fabric

Apply glue onto the wood dowels (#D)
and insert into the top right frame (#2).
Apply glue onto the other ends and
insert shelves (#5,6,7).
1.
Note: shelf size coordinates
with the size of the frame.
I. Insert the barrel nut (#C), Slide the Phillip head screw (#A) through the hole on the
side of the post piece until it bumps against the nut.
II. Use your screwdriver to rotate the barrel nut (#C) until the hole is lined up with the
end of the screw. Hold the barrel nut in position with your screwdriver. Simultaneously
use the wrench to turn the screw. Continue tightening until the bolt is fully seated.
2.
Apply glue onto the wood dowels (#D)
and insert into the top left frame (#1).
Apply glue onto the other ends and
insert shelves (#5,6,7).
1.
I. Insert the barrel nut (#C), Slide the Phillip
head screw (#A) through the hole on the
side of the post piece until it bumps
against the nut.
II. Use your screwdriver to rotate the barrel
nut (#C) until the hole is lined up with the
end of the screw. Hold the barrel nut in
position with your screwdriver.
Simultaneously use the wrench to turn
the screw. Continue tightening until the
bolt is fully seated.
2.

Apply glue onto the wood dowels (#D)
and insert into the bottom right frame (#4).
Apply glue onto the other ends and
insert shelves (#8,9).
1.
I. Insert the barrel nut (#C), Slide the Phillip head screw (#A) through the hole on the
side of the post piece until it bumps against the nut.
II. Use your screwdriver to rotate the barrel nut (#C) until the hole is lined up with the
end of the screw. Hold the barrel nut in position with your screwdriver. Simultaneously
use the wrench to turn the screw. Continue tightening until the bolt is fully seated.
2.
Apply glue onto the wood dowels (#D)
and insert into the bottom left frame (#3).
Apply glue onto the other ends and
insert shelves (#8,9).
1.
I. Insert the barrel nut (#C), Slide the Phillip
head screw (#A) through the hole on the
side of the post piece until it bumps
against the nut.
II. Use your screwdriver to rotate the barrel
nut (#C) until the hole is lined up with the
end of the screw. Hold the barrel nut in
position with your screwdriver.
Simultaneously use the wrench to turn
the screw. Continue tightening until the
bolt is fully seated.
2.

I. Determine exactly where you
want to drill a hole and mark
the spot(s). Be sure that you
hold the drill perpendicular to
the wall. You should drill a
hole that is approximately
the same size as the screw.
II. Insert a flat washer (#H) into
screw (#I). Insert screw
assembly into one end of (#K)
and screw into the plug on the
wall.
III. Insert a flat washer (#H) into
screw (#G). Insert screw
assembly into the other end of
(#K) and screw into the corners
of the top frame. Repeat process
for the other side.
Insert a total of 20 wood plugs to fill the bolt holes.
I. Insert 4 wood dowels (#D) with glue into the
large pre-drilled holes on top of the bottom
frames. Then, apply the top frames onto the
other end of the wood dowels.
II. Insert 4 screws (#B) into the bottom frames.
Insert from below and secure using a Phillips
screwdriver.
1.
2.