Disclaimer: Diagram is for illustrative purposes only.
Pinger Attachment Instructions
Netguard 10 kHz Porpoise & Dolphin Pinger
Netshield 70 kHz Dolphin Anti-Depredation Pinger
Netshield 3 kHz Whale Pinger
= 1 Pinger every 100 meters
For Gill nets, purse seine nets and long lines.
Netguard 60-120 kHz Dolphin Pinger
= 1 Pinger every 200 meters
For Gill nets.
For further detailed instruction
please refer to Pinger instructions
on our website
www.futureoceans.com/pingers
Thank you for choosing Future Oceans Pingers.
Your Pinger is supplied with a battery, ready to use.
Simply follow the Pinger Attachment Instructions and start fishing.
1
2
3
4
Repeat on the other end of Pinger. Pull cable tie closed
firmly so the Pinger fits closely to the float or lead line.
Both ends of the Pinger should be tight to the line.
Cut any excess cable tie to leave a clean finish.
Pull cable tie closed firmly so the Pinger fits
closely to the float or lead line.
Loop one end of the cable tie over the float or lead line
and feed cable tie back in to itself.
Leaving the electronics capsule in the housing,
thread 1 x cable tie through each hole at the ends
of the Pinger housing.
Use 7.5mm (width) x 200mm (length) cable ties.
electronics capsule
external housing
