Futuro Futuro DECORSA INSERT User manual

Futuro Futuro
Futuro Futuro
RANGE HOOD
INSTALLATION MANUAL
MODEL: DECORSA INSERT
NOTE: THE BOTTOM OF THE HOOD SHOULD BE EVEN WITH,
OR SLIGHTLY BELOW, THE BOTTOM OF THE CABINET - NOT ABOVE IT.
FRONT OF HOOD SHOULD LINE UP WITH DOOR.
FEATURE: REAR EXHAUST (THROUGH-WALL VENTING)
THIS MODEL CAN EXHAUST THROUGH THE TOP, OR THE REAR.
TO EXHAUST THROUGH THE REAR (THROUGH WALL):
1.) REMOVE 8 SCREWS & LIFT OUT BLOWER MODULE (AS SHOWN).
2.) DISCONNECT THE POWER PLUG (NOT PICTURED).
3.) TURN THE BLOWER MODULE & RE-INSERT INTO HOOD.
4.) RECONNECT THE POWER PLUG & REPLACE 8 SCREWS.
Filler Panel (U-Channel)
Cabinet depth LESS THAN 12 1/4”
= do not need ller panel
Cabinet depth BETWEEN 12 1/4”
and 13 3/4” = use ller panel
< 12 1/4”
Measure 2 3/8” from
bottom of cabinet,
for ller panel position 1.) Secure ller panel to back of cabinet.
2.) Insert hood & adjust depth so that
front of hood is ush with back of
cabinet door.
3.) Secure adjustment screws.
Flip open the capture panel,
and remove the metal lters.
This provides you with
access to side screw holes.
26” - 28”
from cooktop
to bottom
of hood
Recommended
Installation
Height
1
2
NOTE: PRIOR TO INSTALLATION
Please inspect range hood visually,
as well as connect it to power supply
and test its operation.

Insert hood body into cabinet,
and secure with 4 screws
(2 on each side).
Install the metal lters.
3
Adjust position of top cover as needed,
using the adjustment screw & slot.
Secure the adjustment screw when nished.
7
8
Connect the ductwork.
NOTE: duct should be RIGID type,
(”galvanized” or otherwise),
NOT exible type (dryer vent).
4
Insert, but do not tighten
completely, 1 screw into each
side of the top cover.
6
5
Position the top cover.