G3D T-1000 User manual

1
2
3
4
5
6
7
8
9
10
11
3ACME Thread
4VAT
5VAT Stopper
1Head Stopper
2Build Plate
6Calibration Lever
10 Wifi Reset
9Ethernet Port
8USB Port
7Electronic Panel
11 Power Button
13 Main Switch
14 Fuse Holder
15 Power Cable
12 Handle
13
14
15
12
T-1000 QUICK START GUIDE
This quick start guide explains basic instructions on how to unbox and set up the T-1000 3D printer. For more
information, please refer to the T-1000 manual, available for download at g3dsys.com.
ACCESSORIES CHECKLIST
COMPONENTS
Resin VATScraperBuild Plate Clippers
GUIDE
Quick Guide

UNBOXING ANG SETTING UP THE T-1000
1
2
3
4
TRIM THE TAPED EDGES
Use a cutter to trim the taped edges.
CHECK THE ACCESSORIES
Lift the accessory box handles. Open the accessory
box to check if the accessories are inside.
REMOVE THE ACCESSORY BOX
TILT THE T-1000 BOX
Slightly tilt the T-1000 box. Make sure to hold or
lean the T-1000 box against a wall to prevent from
falling.
6OPEN THE BOTTOM FLAPS
Unfold the bottom flaps of the T-1000 box.
5TRIM THE BOTTOM TAPED EDGES

UNBOXING ANG SETTING UP THE T-1000
7REMOVE THE ACCESSORY FOAM SUPPORT
8LIFT THE T-1000 BOX
Remove the plastic cover of the T-1000.
9LIFT THE T-1000 3D PRINTER
Printer can be heavy for one person. 2 person lift
can be optional. Use the side handles of the printer
to separate the printer from the bottom foam
support. Place the printer on a flat ground.
10 REMOVE THE HEAD STOPPER
Rotate the head stopper counter clockwise to
detach from the build plate assembly.
11 INSERT THE BUILD PLATE
12 LOCK THE HEAD STOPPER
Rotate the head stopper clockwise to lock. Do not
overtighten.

UNBOXING ANG SETTING UP THE T-1000
13
VAT INSERT
UNTIGHTEN THE VAT STOPPERS
Rotate the (4) four vat stoppers counter clockwise
to loosen, no need to remove the vat stoppers from
the VAT insert.
14 INSERT THE VAT
15 TIGHTEN THE VAT STOPPERS
Tighten the (4) four VAT stoppers only enough to
snug them against the VAT. Do not overtighten the
VAT stoppers because it can damage the VAT.
16 PLUG THE POWER CABLE
Insert the power cable into a power outlet.
Uninterruptible power supply recommended.
17
ON
TURN ON THE MAIN SWITCH
Press the main switch on, located at the back panel
of printer.
18 PRESS THE POWER BUTTON
Push power button for 2 - 3 seconds until a red led
illuminates from the power button.