Galaxy Audio ANY SPOT AS-DCTVMBP User manual

User's Guide
TWINBODYPACK
CHARGINGSTAND
Bodypack charging stand
Body-pack Transmitter Body-pack Receiver
AS -D CT VM BP
ANYSPOT
®

INTRODUCTION
-1-
Thank you for purchasing our twin bodypack charging
stand for TRAVELER wireless microphone bodypacks.
Please read this manual carefully before using.

-2-
DESCRIPTION OF FUNCTIONS
(2)
(1)
(3)
(4)
AS-DCTVMBP
1. Fully Charged Indicator (Indicates OK with green
LED)
2. Charging Indicator (Indicates ON with amber LED)
3. DC Power connector
4. Charging stand for TRAVELER, wireless microphone
bodypacks.

SETUP AND OPERATION
1. Plug the AC adapter into an AC outlet of the voltage
specified on the adapter. Plug the DC cable into the DC
in Jack on the charger stand. The charger will perform a
self-test with the following indications: Both OK
(GREEN)indicators blink, then both ON (AMBER)
indicators blink. If the unit passes the test, both ON
(AMBER) indicators will blink one more time.
2. Rechargeable batteries of only the NI-CD or NI-MH
type must be installed in the bodypacks. Insert the
bodypacks fully into the charger stand. The ON
(AMBER) LED will light indicating charging in progress.
3. The OK (GREEN) LED will light when the batteries are
fully charged.
-3-

ATTENTION:
Avoid Excessive Heat
Don't leave the charging stand in the hot sun, on a
radiator, or near other sources of high temperature.
Avoid Rough Handling
Charging stand may be damaged if dropped.
USE only Ni-CD or Ni-MH Rechargeable Batteries.
-4-

TROUBLESHOOTING
Problem
Charging Indicator (ON
AMBER) Keeps Flashing
Solution
Make sure the batteries are
the rechargeable type.
Make sure bodypack is
installed properly. Some belt
clips may need to be changed
or removed to allow full
insertion of the bodypack into
the charger.
Make sure the batteries are
installed properly.
Make sure the AC Adapter is
plugged into an outlet. Make
sure DC cable is plugged into
charger stand.
ON (AMBER) LED does not
light with bodypack
inserted.
FEATURES
The AS-DCTVMBP features a PWM charging control
with smart charging shut off when the batteries are fully
charged. The high efficiency design takes only 3 to 4
hours for a full bodypack recharge.
-5-

SPECIFICATIONS
Number of charging
compartments
Power requirement
OK (GREEN) LED lit.
ON (AMBER) LED lit
Charging current
Charging time Ni-MH.
(1300mAH)
Charging control detector,
Dimensions (D*W*H)
Weight
2 (receiver or transmitter) or
multi-series
115V or 230V AC adaptor
12V DC, 500mA
Bodypack fully charged
Charging in progress
450 ~ 500 mA
3 ~ 4 hours
PWM control,full charge
power-off one-time battery
detector
5.47" x 3.94" x 3.54"
(139x100x90 mm)
5.64 oz (160 g)
-6-
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

V20210914
2021Copyright Galaxy Audio Inc.
www.galaxyaudio.com/support/warranty
https://www.galaxyaudio.com/support/warranty
User's Guide
TWINBODYPACK
CHARGINGSTAND
AS -D CT VM BP
ANYSPOT
®
Product Page