Garden Furniture Centre LDHR009-200KB-S Operation and maintenance manual

Infrared Patio Heater
Safety Instructions
and Operation Manual
Model: LDHR009‐200KB‐S
Brief Introduction
This product is infrared radiant heater with remote control and IP 65 approved .It is almost
unlimited used in outdoor ,such as open bars, courtyard, plaza, station, and construction site in
winter etc. This patio heater is energy‐efficient, convenient, environmentally friendly and for
better life etc. And add the Bluetooth speakers and LED lighting. Connecting your mobile phone or
PC then can play the music and control LED lighting.
Important Safety Instructions
When using electrical appliances, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, or injury to persons, including the following:.
Read all instructions before using this heater
This heater is hot when in use .To avoid burns,do not let bare skin touch hot surfaces.If
provided ,use handles when moving this heater.Keep combustible materials,such as
furniture,pillows ,bedding ,papers,clothes and curtains at least 0.9m from the front of the
heater.
Extreme caution is necessary when any heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
Always unplug heater when not in use
This heater is not intended for use in bathrooms, laundry areas and similar locations. Never
locate heater where it may fall into a bathtub or other water container.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic
area and where it will not be tripped over.
Connect to properly grounded outlets only.
To disconnect heater, turn controls off, then remove plug from outlet.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the heater.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on
soft surfaces, like a bed, where openings may become blocked.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline,
paint, or flammable liquids are used or stored.
Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord
or relocatable power tap (outlet/power strip).
Check if the voltage indicated on the nameplate of the appliance corresponds to the local
mains voltage before you connect the appliance.
The appliance is not located immediately below a wall socket‐outlet.
The casing and the front cover of the appliance become extremely hot during operation. Pay
attention that, no combustible material due to wind or other environmental influences
covers or obstructs the appliance, such as curtains, marquees, flags, plastic foil etc. Do not
touch the appliance. Caution! Risk of scald injury!
In case of improper use, there is a risk of electrical shock and/or fire hazard. Operation of the
appliance must be discontinued and remove the mains plug immediately. Do not try to repair
the appliance by your‐self. Please contact with the service agent or a suitably qualified
electrician for maintenance.
Remove the plug from the power outlet and wait until the appliance is sufficiently cooled off
before cleaning.
The appliance must only be mounted by an authorized specialist, paying attention to the
relevant regulations of the power supply companies and the regional construction
regulations.

Save These Instructions
Specifications
Specification □LHRR009‐200KB‐S
Voltage (V) □220‐240V～
Power consumption (W) □2000W
IP code □IP65
Infrared receiving Angle □60°±5°
Bluetooth receiver distance □≥20M
The speaker power □3W×2
BLUETOOTH OPERATION
A free Bluetooth App is available to download for this heater for either your iPhone, iPad or
Android device.
The 'Sunkare Heater' App will allow you to connect remotely to many heaters and control them
independently. Control functions include:
On/Off
Variable heat output from 25% to 100%
Timer with auto shut off
Password connection to heaters
Individual heater identification and control
Control LED lighting display mode, brightness and color
Turn on/off blue tooth speaker or enter into blue tooth pairing mode
To
download, search for 'Sunkare ' in your App store and add to your device.
Bluetooth speakers connecting steps
1.In standby position, short press the remote control button ,turn on the power of the blue tooth
speakers,then long press this button in order to enter into blue tooth pairing mode.
2.open the blue tooth function in your iPhone, iPad or Android device, find the “LIANG DI” in the
device lists, then connecting.
3.Connecting successful will have prompt tone, then you can play music by your iPhone, iPad or
Android device.
4.Button again, it will turn off the blue tooth speaker, The next open will automatically
connect you have paired devices.
RESET OPERATION
Press the Reset button shortly, the power will be adjusted accordingly(Low, Middle ,High,
ON/OFF)
Press the Rest button for at least 4 seconds ,the heater will restore factory settings
Remote Control Instructions
Button Graphic Feature
Up Arrow Up one heating level
Turn off the
speaker
Short press,turn on/off the speaker
Long press,enter into blue tooth pairing mode
Down Arrow Down one heating level
LED light on Turn on the LED light
LED light off Turn off the LED light
On
To switch the heater on:
Press ON. The patio heater has a soft start function of
33% power. 4 seconds after the heater has been turned
on, it will automatically switch to the last heating level
used. In case of the first‐time use, after 4seconds the
heater will automatically switch to 100% power.
Off
To switch the heater off:
Press OFF. The heater will switch to standby mode(the
receiver indicator will light up).

Notice：
Use 2 pieces AAA size 1.5V batteries in the remote control. Remove the battery when not use for long
time, thus the lifespan of remote control can be extended.
Choose the same specification battery when replacing the battery inside, otherwise it may cause
remote control not work , thereby affect the normal use of the heater.
Please contact service agent for further help if you need the function.
The remote control function may be out of work if there is a barrier between the remote control and
heater .
Replacing the batteries duly so as not to affect the normal use of heater and remote control.
Operation Instruction
Remove all package material (including anti‐vibration object of the lamp) and check the
appliance, supply cord and the plug for signs of damage.
Pay attention to the mounting place and all mounting material(dowels, screws). Ensure they
are suitable and stable enough for mounting and lastingly holding of the appliance.
Before mounting, the minimum safe mounting distances and tilt angles shown in the figures
must be strictly followed.
The distance between the bottom edge of the appliance and the floor must be at least 1.8 M.
See figure 2.
There must be a distance of at least 0.25 M between the appliance and the ceilings, roofs or
other covers. See figure 2.
There must be a distance of at least 0.5 M at each side between the appliance and walls or
the like. See figure 2.
Recommended degree to mounting surface is 45°. See figure 3.
Pay attention that, the installation of the appliance must not add excessive wind load.
Fix the mounting bracket to the ceiling l first. Ensure that the place to be installed is secure
and firm. Or connect the appliance to the stand.
Adjust the desired angle of radiation and fest screw all screws. Check regularly the screw's
connection. Mechanical bearing pressure and oscillation due to wind or rain could lead to
loose.
Plug in the power source and operate the remote control. Then observe, whether during the
first 10‐15 minutes the appliance works trouble‐free.
If you do not use,please remove battery socket.
Figure1: Mounting bracket and anchor dowels
provided. Connection from the wall to the infrared
heater.
Figure2: Min. distance to floor, ceiling and wall.
Figure3: Tilt angle. Figure 4: Max.remote distance

Cleaning and Maintenance
This appliance is consist of a robust and maintenance‐free aluminum casing with a protection
cover. No user serviceable parts inside.
Before cleaning,remove the plug from the power outlet and wait until the appliance is
sufficiently cooled off.
Wipe the appliance only with clean and lint‐free cloth or a soft brush.
Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning!
Can use alcohol to clean the appliance.
To protect against electrical shock and danger of life, do not immerse cord, plug, or any part
of the appliance in water or other liquid.
For heating element replacement, please contact the manufacturer or its service agent or a
similarly qualified person.
Any other service, please contact with the service agent or a suitably qualified electrician.
Storage
Do not route cord when heater storage, or heater is not in use.
Disposal
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
Customer Service
Repairs must be carried out by authorized specialists, thus ensuring electrical safety.
Please contact with the service agent or a suitably qualified electrician.
Improper repairs could lead to danger to the user.
This warranty does not cover damage of failure which results from alteration, accident,
misuse, abuse, neglect, commercial use or improper maintenance.
In line with our policy of continuous product development we reserve the right to change the
product and documentation specifications without notice.