Gardeners 8600331 User manual

1-800-876-5520 • gardeners.com
[e-mail]
8% of our profits go back to our communities.
Learn more at gardeners.com/FoRCE-FoR-GoOD
V Rev /#
Garden Tub Cleanup Cart
Parts List
() FRAME PIECES () LARGE WASHERS
() HANDLE () COTTER PINS
() WHEEL AXLE () FRONT SUPPORT BAR
() PHILLIPS HEAD BOLTS () SHORT BOLTS
() LARGE RING () SMALL RING
() LONG BOLTS () NUTS
() BASKET U SUPPORT WRENCH
() BASKET SIDE BRACES
() WHEELS
() SMALL WASHERS
LARGE
WASHER
WHEEL AXLE
WHEEL
WHEEL
WASHER
COTTER PIN
FRAME PIECES
FRONT SUPPORT BAR
(with tab)
NUT
NUT
WHEEL AXLE
LARGE RING
SMALL RING
BASKET U
SUPPORT
SHORT BOLTS
NUTS
HANDLE
FRAME
PIECES
PHILLIPS
HEAD BOLTS NUT
NUT
SMALL
WASHER
SMALL
WASHER
1. Insert the FRONT SUPPORT BAR and WHEEL AXLE into
FRAME PIECES as shown. Then, secure the FRONT SUPPORT
BAR with a NUT on each end.
2. Slide a LARGE WASHER, a WHEEL, and then another
LARGE WASHER onto each end of the WHEEL AXLE. Place
the COTTER PINS through the holes in the WHEEL AXLE
and spread the ends to secure them into place.
4. Align two holes in the SMALL RING with the bottom holes
in the BASKET U SUPPORT and secure with SHORT BOLTS and
NUTS. Align two holes in the LARGE RING with the top holes in
the BASKET U SUPPORT and again secure with SHORT BOLTS
and NUTS.
3. Slide the HANDLE on
top of the FRAME PIECES.
Place the PHILLIPS HEAD
BOLTS through the lined
up holes and slide a
SMALL WASHER onto the
end. Screw a NUT onto
each of them.
Tools required
Phillips screwdriver

The Garden Tub Cleanup Cart fits an  gallon tubtrug. It can be left outdoors year-round. If the powder-
coated finish gets nicked or scratched, use an exterior-grade metal paint to prevent rust.
BASKET
SIDE
BRACE
BASKET SIDE
BRACE
SHORT
BOLTS
NUT
NUT
NUT
LONG BOLTS
NUT
NUT
SHORT BOLT
5. ALign the holes in a BASKET SIDE BRACE with two
holes in the SMALL and LARGE RINGS. Place a SHORT
BOLT through the bottom set of holes and secure
with a NUT. NOTE: Skip the top set of holes. Repeat to
attach the remaining BASKET SIDE BRACE to the other
side of the basket.
6. Place the assembled basket into the cart as
shown, lining up the hole in the bottom with the
hole in the FRONT SUPPORT BAR and the holes in
the sides with the holes in the FRAME PIECES. Slide
a LONG BOLT through both sets of holes in the sides
and secure with NUTS.
7. Insert a SHORT BOLT through the aligned holes in the FRONT SUPPORT BAR and BASKET U SUPPORT, and secure with a NUT.
Then, tighten all hardware fully. Your assembly is now complete!
PLEASE
RECYCLE
For more great gardening products or to access our advice libary, please visit gardeners.com